2003 Mazda Bongo

Brake pipe corroded, covered in grease or other material all arounds (1.1.11 (c))

Oil leak, but not excessive (8.4.1 (a) (i))

Rear Coil spring mounting corroded but not seriously weakened both sides (5.3.1 (b) (i))

Subframe mounting repair covered in underseal front and back (5.3.6 (a) (i))

Suspension spring mounting repair covered in underseal all around (5.3.6 (a) (i))

Offside Front Headlamp not working on main beam (4.1.1 (a) (ii))

Nearside Rear Brake pipe connection leaking on a hydraulic braking system (1.1.11 (b) (ii)) DANGEROUS

Offside Rear Tyre has a tear, caused by separation or partial failure of its structure (5.2.3 (d) (ii)) DANGEROUS

Brake pipe corroded, covered in grease or other material all arounds (1.1.11 (c))

Oil leak, but not excessive (8.4.1 (a) (i))

Rear Coil spring mounting corroded but not seriously weakened both sides (5.3.1 (b) (i))

Subframe mounting repair covered in underseal front and back (5.3.6 (a) (i))

Suspension spring mounting repair covered in underseal all around (5.3.6 (a) (i))

All 4 inner wheel arch have had repairs and have been undersealed/sealer before test unable to inspect

Brake pipe corroded, covered in grease or other material All undersealed (1.1.11 (c))

Nearside Front Service brake binding but not excessively (1.2.1 (f))

Nearside Front inner wheel arch in engine bay been repaired but unable to inspect due to underseal/sealer

Nearside Rear Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Nearside Rear Coil spring corroded (5.3.1 (b) (i))

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive shocker (5.3.6 (a) (i))

Nearside Rear Suspension spring mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Nearside Rear Upper Suspension spring mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Offside Rear Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Offside Rear Coil spring corroded (5.3.1 (b) (i))

Offside Rear Inner sill has had repair and has been undersealed

Offside Rear Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Offside Rear Suspension spring mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Offside Rear Upper Suspension spring mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

heavily underseal underside of vehicle

underbody corrosion

Nearside Front Anti-roll bar ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Nearside Front Anti-roll bar linkage ball joint excessively worn (5.3.4 (a) (i))

All 4 inner wheel arch have had repairs and have been undersealed/sealer before test unable to inspect

Brake pipe corroded, covered in grease or other material All undersealed (1.1.11 (c))

Nearside Front Service brake binding but not excessively (1.2.1 (f))

Nearside Front inner wheel arch in engine bay been repaired but unable to inspect due to underseal/sealer

Nearside Rear Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Nearside Rear Coil spring corroded (5.3.1 (b) (i))

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive shocker (5.3.6 (a) (i))

Nearside Rear Suspension spring mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Nearside Rear Upper Suspension spring mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Offside Rear Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Offside Rear Coil spring corroded (5.3.1 (b) (i))

Offside Rear Inner sill has had repair and has been undersealed

Offside Rear Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Offside Rear Suspension spring mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Offside Rear Upper Suspension spring mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

heavily underseal underside of vehicle

underbody corrosion

Brake performance unable to be tested Deu to corrosion. (1.2.1 (g))

Emissions unable to be completed Excessive leeks in system. (8.2.2.2 (e))

Exhaust has a major leak of exhaust gases Both flexi pipes (6.1.2 (a))

Nearside Front Suspension arm ball joint excessively worn (5.3.4 (a) (i))

Nearside Front Vehicle structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting Strut top (6.2.2 (d) (i))

Nearside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Nearside Rear Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced (6.1.1 (c) (i))

Offside Front Vehicle structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting Strut top (6.2.2 (d) (i))

Offside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Offside Outer Vehicle structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting Sill (6.2.2 (d) (i))

Offside Rear Seat belt missing (7.1.2 (a))

Offside Rear Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced (6.1.1 (c) (i))

Rear Boot lid corroded and likely to cause injury Corroded. (6.2.1 (a) (i))

Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Exhaust fumes causing a danger to health of persons on board (6.1.2 (b) (ii)) DANGEROUS

Offside Front Tyre has ply or cords exposed (5.2.3 (d) (ii)) DANGEROUS

Brake pipe corroded, covered in grease or other material All under side covered with underseal. Also all steel pipes. (1.1.11 (c))

Nearside Front Inner Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Oil leak, but not excessive (8.4.1 (a) (i))

Nearside Front Suspension component mounting prescribed area is corroded but not considered excessive upper spring mount (5.3.6 (a) (i))

underside of vehicle coverd with underseal unable to fully inspect

Front Windscreen washer not working (3.5 (a))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner sill (5.3.6 (a) (i))

Offside Seat belt anchorage prescribed area strength or continuity significantly reduced outer sill (7.1.1 (a) (i))

Nearside Front Suspension component mounting prescribed area is corroded but not considered excessive upper spring mount (5.3.6 (a) (i))

underside of vehicle coverd with underseal unable to fully inspect

Nearside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Offside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Offside Seat belt anchorage prescribed area strength or continuity significantly reduced (7.1.1 (a) (i))

Nearside Front Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

under side under sealed all over welding repaires

Exhaust has a major leak of exhaust gases Back box (6.1.2 (a))

Nearside Front Inner Suspension component mounting prescribed area excessively corroded significantly reducing structural strength wheel arch (5.3.6 (a) (i))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner sill (5.3.6 (a) (i))

Nearside Rear Vehicle structure excessively corroded within 30cm of towbar mounting crossmember (6.1.6 (i) (i))

Offside Front Inner Suspension component mounting prescribed area excessively corroded significantly reducing structural strength wheel arch (5.3.6 (a) (i))

Offside Rear Vehicle structure excessively corroded within 30cm of towbar mounting crossmember (6.1.6 (i) (i))

Central Upper Stop lamp(s) non-obligatory stop lamp not working (4.3.1 (a) (ii))

Nearside Front Inner Suspension component mounting prescribed area is corroded but not considered excessive sill not within 12" of a loadbearing member (5.3.6 (a) (i))

Nearside Front Lower Anti-roll bar linkage ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Nearside Front Lower Suspension arm ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Offside Rear Service brake fluctuating, but not excessively (1.2.1 (e))

Offside Rear Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Surface corrosion to rear chassis rails

Emissions not tested (8.2.2.2 (e))

Exhaust has a major leak of exhaust gases centre flexi (6.1.2 (a))

Nearside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength wheel arch inner - 2 separate areas. (5.3.6 (a) (i))

Offside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength wheel arch inner (5.3.6 (a) (i))

Offside Stop lamp(s) not working (4.3.1 (a) (ii))

Rear Tyre(s) with different structures are fitted across the same axle (5.2.3 (c))

Nearside Rear Tyre slightly damaged/cracking or perishing tyre split but not deep enough to expose cords (5.2.3 (d) (ii))

Offside Front Tyre slightly damaged/cracking or perishing sidewall split but not deep enough to expose cords (5.2.3 (d) (ii))

Oil leak, but not excessive (8.4.1 (a) (i))

Rear Service brake fluctuating, but not excessively offside and nearside (1.2.1 (e))

Rear chassis rails surfaces corroded

offside rear light unit slightly condensated

slight cracking in sidewall o\s\r tyre

Offside Rear Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

N\s\r tyre starting to split.

slight cracking in sidewall o\s\r tyre

Exhaust emits an excessive level of metered smoke for a turbo charged engine (7.4.B.3b)

Offside Registration plate lamp not working (1.1.C.1d)

Nearside Headlamp not working on dipped beam (1.7.5a)

Offside Rear Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Offside Rear fog lamp not working (1.3.2b)

Rear fog lamp not working (1.3.2b)

Coolant leak

Front Brake pad(s) wearing thin (3.5.1g)

Nearside Rear Anti-roll bar rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Offside Rear Anti-roll bar rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

both sills corroded

n/s/r tyre side wall cracked

o/s/r tyre side wall cracked

Front Brake pad(s) wearing thin (3.5.1g)

Offside Outer Vehicle structure has slight corrosion (6.1.B.2)

Rear Brake pad(s) wearing thin (3.5.1g)

Centre Front Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Nearside Front Anti-roll bar ball joint dust cover excessively damaged so that it no longer prevents the ingress of dirt (2.4.G.2)

Offside Front Anti-roll bar ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt (2.4.G.2)

Offside Front Headlamp aim beam image obviously incorrect (1.8.A.1b)

Offside Front Side repeater incorrect colour (1.4.A.2f)

Parking brake lever has no reserve travel (3.1.6b)

Service brake: efficiency below requirements (3.7.B.7)

Front Brake pad(s) wearing thin (3.5.1g)

Offside Outer Vehicle structure has slight corrosion (6.1.B.2)

Rear Brake pad(s) wearing thin (3.5.1g)

Nearside Front position lamp(s) not working (1.1.A.3b)

Nearside Rear position lamp(s) not working (1.1.A.3b)

Nearside Registration plate lamp not working (1.1.C.1d)

Offside Front position lamp(s) not working (1.1.A.3b)

Offside Rear fog lamp not working (1.3.2b)

Offside Rear position lamp(s) not working (1.1.A.3b)

Offside Registration plate lamp not working (1.1.C.1d)

Windscreen washer provides insufficient washer liquid (8.2.3)

corrosion under vehicle