2007 Mazda Bongo

Central Front Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Front Brake pipe corroded, covered in grease or other material both (1.1.11 (c))

Front Suspension arm pin or bush worn but not resulting in excessive movement both (5.3.4 (a) (i))

Rear Brake pipe corroded, covered in grease or other material both (1.1.11 (c))

Rear Suspension arm pin or bush worn but not resulting in excessive movement both (5.3.4 (a) (i))

underside and components rather corroded

Emissions not tested (8.2.2.2 (e))

Exhaust has a major leak of exhaust gases (6.1.2 (a))

Nearside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength crossmember near front subframe mounting (5.3.6 (a) (i))

Nearside Headlamp aim too high (4.1.2 (a))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill (5.3.6 (a) (i))

Nearside Rear Vehicle structure excessively corroded within 30cm of towbar mounting floor (6.1.6 (i) (i))

Offside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength crossmember near front subframe mounting (5.3.6 (a) (i))

Offside Headlamp aim too high (4.1.2 (a))

Offside Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced inner sill (6.1.1 (c) (i))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength chassis rail near rear shock mounting (5.3.6 (a) (i))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner sill to chassis rail support (5.3.6 (a) (i))

Offside Rear Vehicle structure excessively corroded within 30cm of towbar mounting floor (6.1.6 (i) (i))

Windscreen washer not working (3.5 (a))

Front Suspension component mounting prescribed area is corroded but not considered excessive subframe mounting areas (5.3.6 (a) (i))

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive chassis rail near rear shock mounting (5.3.6 (a) (i))

Power steering component has slight seepage from a component union to power steering pump and at rack (2.1.5 (a))

Power steering pipe/hose slightly corroded (2.1.5 (g) (i))

Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

all inner arches corroded

Front Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Oil leak, but not excessive (8.4.1 (a) (i))

Power steering component has slight seepage from a component (2.1.5 (a))

Rear Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Rear Brake pipe corroded, covered in grease or other material both (1.1.11 (c))

Rear fog lamp not working (4.5.1 (a) (ii))

Front Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Oil leak, but not excessive (8.4.1 (a) (i))

Power steering component has slight seepage from a component (2.1.5 (a))

Rear Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Rear Brake pipe corroded, covered in grease or other material both (1.1.11 (c))

Brake pipe corroded, covered in grease or other material all brake pipes coated (1.1.11 (c))

Nearside Rear Coil spring corroded (5.3.1 (b) (i))

Offside Rear Coil spring corroded (5.3.1 (b) (i))

Brake pipe corroded, covered in grease or other material all brake pipes undersealed (1.1.11 (c))

vehicle undersealed

Nearside Front Headlamp not working on dipped beam (4.1.1 (a) (ii))

Nearside Front Headlamp not working on main beam (4.1.1 (a) (ii))

Nearside Seat belt anchorage prescribed area strength or continuity significantly reduced outer sill (7.1.1 (a) (i))

Offside Front Headlamp not working on dipped beam (4.1.1 (a) (ii))

Offside Front Headlamp not working on main beam (4.1.1 (a) (ii))

Offside Suspension component mounting prescribed area excessively corroded significantly reducing structural strength outer sill (5.3.6 (a) (i))

Brake pipe corroded, covered in grease or other material all brake pipes undersealed (1.1.11 (c))

Offside Rear Outer Brake pad(s) wearing thin (1.1.13 (a) (ii))

vehicle undersealed

Front Headlamp deteriorated but light output not reduced both (1.7.5a)

Front Track rod end ball joint dust cover deteriorated, but preventing the ingress of dirt both (2.2.C.1c)

Front Headlamp deteriorated but light output not reduced both (1.7.5a)

All position lamps not working (1.1.A.3b)

Fuel system component leaking (7.2.3)

Offside Front Track rod end ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt (2.2.C.1c)

Offside Rear Rear fog lamp not working (1.3.2b)

Rear fog lamp tell tale not working (1.3.1b)

Front Headlamp deteriorated but light output not reduced both (1.7.5a)

Nearside Front Track rod end ball joint dust cover deteriorated, but preventing the ingress of dirt (2.2.C.1c)

Horn not working (1.6.2a)

n/s/r body poor

Front Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Horn not working (1.6.2a)

Nearside Headlamp aim too high (1.8)

Nearside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Nearside Rear Tyre has a bulge, caused by separation or partial failure of its structure (4.1.D.1b)

Nearside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Offside Front Suspension arm corroded and seriously weakened (2.4.G.1)

Offside Headlamp aim beam image obviously incorrect (1.8.A.1b)

Offside Inner Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Rear Tyre has a bulge, caused by separation or partial failure of its structure (4.1.D.1b)

n/s/r body poor

Offside Front Suspension arm has slight play in a pin/bush (2.4.G.2)

Nearside Front Subframe mounting prescribed area is excessively corroded (2.4.A.3)

Nearside Headlamp aim beam image obviously incorrect (1.8.A.1b)

Nearside Rear Subframe mounting prescribed area is excessively corroded (2.4.A.3)

Offside Front Subframe mounting prescribed area is excessively corroded (2.4.A.3)

Offside Headlamp aim beam image obviously incorrect (1.8.A.1b)

Offside Rear Subframe mounting prescribed area is excessively corroded (2.4.A.3)

Offside Seat belt anchorage prescribed area is excessively corroded (5.2.6)

Rear fog lamp not working (1.3.2b)

Front Exhaust has a minor leak of exhaust gases (7.1.2)

Nearside Front Anti-roll bar ball joint dust cover excessively damaged so that it no longer prevents the ingress of dirt (2.4.G.2)

Nearside Front Headlamp excessively deteriorated so that the light output is severely reduced (1.7.5a)

Offside Front Anti-roll bar ball joint dust cover excessively damaged so that it no longer prevents the ingress of dirt (2.4.G.2)

Offside Front Headlamp excessively deteriorated so that the light output is severely reduced (1.7.5a)

Rear fog lamp not working (1.3.2b)

Windscreen washer provides insufficient washer liquid (8.2.3)

Front Exhaust has a minor leak of exhaust gases (7.1.2)

Nearside Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Nearside Rear brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Offside Body has slight corrosion (6.1.B.2)

Offside Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Offside Rear brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Vehicle structure has slight corrosion (6.1.A.1)

Horn not working (1.6.2a)

Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.5b)

Nearside Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Nearside Rear brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Offside Body has slight corrosion (6.1.B.2)

Offside Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Offside Rear brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Parking brake: parking brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.7)

Vehicle structure has slight corrosion (6.1.A.1)

Offside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Nearside Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Offside Body or chassis has an unsatisfactory modification, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Offside Rear Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

n/s rear inner wheel arch corroded

o/s front inner sill corroded

Nearside Front Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Nearside Front Track rod end ball pin shank loose (2.2.B.1c) DANGEROUS

n/s rear inner wheel arch corroded

o/s front inner sill corroded