1996 MG Mgf

Offside Front Steering rack has slight free play detected at steering wheel (2.3 (a) (i))

car heavily undersealed underside

Car heavily undersealed

Nearside Rear Inner Vehicle structure is corroded but structural rigidity is not significantly reduced Wings (6.1.1 (c) (i))

Offside Rear Inner Vehicle structure is corroded but structural rigidity is not significantly reduced Wings (6.1.1 (c) (i))

Exhaust carbon monoxide content at idle exceeds default limits (8.2.1.2 (b))

Exhaust hydrocarbon content after 2nd fast idle exceeds default limits (8.2.1.2 (b))

Nearside Rear Position lamp not working (4.2.1 (a) (ii))

Nearside Rear Inner Vehicle structure is corroded but structural rigidity is not significantly reduced Wing (6.1.1 (c) (i))

Offside Rear Inner Vehicle structure is corroded but structural rigidity is not significantly reduced Wing (6.1.1 (c) (i))

Underside heavily undersealed

underside heavily undersealed

Nearside Rear Service brake requirements only just met. It would appear that the braking system requires adjustment or repair (1.2.1 (c))

under side heavily undersealed

Offside Front slight play in track rod

Nearside Rear Inner Suspension component mounting prescribed area is inadequately repaired sill (5.3.6 (a) (i))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength floor (5.3.6 (a) (i))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength outer sill/inner wheel arch (5.3.6 (a) (i))

Offside Rear Suspension component mounting prescribed area is inadequately repaired floor (5.3.6 (a) (i))

Nearside Front Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))

Offside Front Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))

floor heavily undersealed

car underside very heavily undersealed all over

Car heavily undersealed covering floor , suspension and brake pipes

Parking brake efficiency below requirements (1.4.2 (a) (i))

Rear Fuel pipe insecure (6.1.3 (a) (i))

Stop lamp(s) remains on when the brakes are released Cord tied to pedal (4.3.2 (a) (iii)) DANGEROUS

Car heavily undersealed covering floor , suspension and brake pipes

Nearside Rear Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Offside Rear Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Welding at rear heavily undersealed

Exhaust carbon monoxide content after 2nd fast idle exceeds manufacturer's specified limits (8.2.1.2 (a))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength Inner sill/wing (5.3.6 (a) (i))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength Floor and inner wing (5.3.6 (a) (i))

Brake disc worn, pitted or scored, but not seriously weakened Both rear (1.1.14 (a) (ii))

Brake pad(s) wearing thin Both front inner brake pads may be worn (1.1.13 (a) (ii))

Nearside Rear Floor corroded

Parking brake minimum requirements just met

Nearside Rear Vehicle structure has slight corrosion (6.1.A.1)

Nearside Rear Brake pad(s) less than 1.5 mm thick (3.5.1g)

Nearside Rear Vehicle structure has slight corrosion (6.1.B.2)

Nearside Rear Vehicle structure has slight corrosion Floor at subframe (6.1.B.2)

Offside Front Steering arm

Rear Brake pad(s) wearing thin (3.5.1g)

Offside Front Steering arm has slight play

Rear Brake pad(s) wearing thin (3.5.1g)

Rear floor corroded at subframe

Exhaust emissions carbon monoxide content after 2nd fast idle excessive (7.3.D.3)

Exhaust emissions carbon monoxide content at idle excessive (7.3.D.4)

Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Windscreen washer provides insufficient washer liquid Not hitting windscreen (8.2.3)

Front Brake pad(s) wearing thin (3.5.1g)

Rear Brake pad(s) wearing thin (3.5.1g)

Vehicle structure has slight corrosion Rear floor on both sides at subframe mounts (6.1.B.2)

Exhaust emissions carbon monoxide content after 2nd fast idle excessive (7.3.D.3)

Rear Registration plate lamp not working (1.1.C.1d)

nearside rear tyre worn on inside

rear panel next to floor and sub-frame corroded on both sides

Nearside Front Track rod end ball joint has slight play (2.2.B.1f)

Exhaust emissions Lambda reading after 2nd fast idle outside specified limits (7.3.D.3)

Exhaust emissions carbon monoxide content after 2nd fast idle excessive (7.3.D.3)

Nearside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Exhaust emissions carbon monoxide content after 2nd fast idle excessive (7.3.D.3)