2005 Mazda Bongo

Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Nearside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Front Obligatory mirror slightly damaged (3.3 (b) (i))

Offside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

Suspension component mounting prescribed area is corroded but not considered excessive nearside and offside sills (5.3.6 (a) (i))

Exhaust has a major leak of exhaust gases (6.1.2 (a))

Offside Rear Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting (6.2.2 (d) (i))

Rear Exhaust mounting defective (6.1.2 (a))

Windscreen washer provides insufficient washer liquid (8.2.3)

Emissions not tested will not rev out (7.3.A.1)

Nearside Front Inner Body has a sharp edge caused by damage sill (6.1.C.1)

Nearside Front Windscreen wiper does not clear the windscreen effectively (8.2.2)

Nearside Rear Shock absorber has a serious fluid leak (2.7.3)

Offside Front Windscreen washer provides insufficient washer liquid (8.2.3)

Offside Front Windscreen wiper does not clear the windscreen effectively (8.2.2)

Rear fog lamp tell tale not working (1.3.1b)

Offside Front seat cover missing

corrosion round wheel archs

front and rear springs rusting

standing rust on discs front and rear springs rusting

Nearside Front Brake pipe slightly corroded (3.6.B.2c)

Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Nearside Suspension arm has excessive play in a ball joint (2.4.G.2)

Offside Front Anti-roll bar has excessive play in a ball joint (2.4.G.2)

Offside Front Brake pipe excessively corroded (3.6.B.2c)

Nearside Front Brake pipe slightly corroded (3.6.B.2c)

Offside Rear Anti-roll bar rubber mounting deteriorated but not resulting in excessive movement (2.4.G.2)

Rear Brake pad(s) wearing thin (3.5.1g)

Nearside Front suspension has excessive play in a lower suspension ball joint (2.5.B.1a)

Offside Rear Registration plate lamp not working (1.1.C.1d)

Offside Rear Anti-roll bar rubber mounting deteriorated but not resulting in excessive movement (2.4.G.2)

Rear Brake pad(s) wearing thin (3.5.1g)

Centre Exhaust has a major leak of exhaust gases (7.1.2)

Nearside Front Anti-roll bar linkage has excessive play in a ball joint (2.4.G.2)

Offside Front Anti-roll bar linkage has excessive play in a ball joint (2.4.G.2)

Front Brake pad(s) wearing thin (3.5.1g)

Nearside Front Headlamp not working on dipped beam (1.7.5a)

Nearside Rear Statutory seat belt missing (5.1.1)

Offside Rear Statutory seat belt missing (5.1.1)