2016 Honda Integra

Nearside Front Tyre slightly damaged Outer side wall (5.2.3 (d) (ii))

Offside Windscreen wiper blade defective (3.4 (b) (i))

Slight play in rear suspension both sides.

Nearside Rear Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii)) DANGEROUS

Offside Rear Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii)) DANGEROUS

Rear Brake disc worn, pitted or scored, but not seriously weakened Slight lipped (1.1.14 (a) (ii))

Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

Rear Inner Tyre worn close to legal limit/worn on edge Both sides worn on edge and out of shape. (5.2.3 (e))

Windscreen damaged but not adversely affecting driver's view (3.2 (a) (i))

Both side headlamp beam pattern 'bleeding out'

Offside Front Brake fluid close to minimum mark (1.1.10 (d) (ii))

Both side headlamp beam pattern 'bleeding out'

Central Front Registration plate does not conform to the specified requirements characters too small 65mm (0.1 (d))

Offside Front Brake fluid close to minimum mark (1.1.10 (d) (ii))

Nearside Windscreen wiper blade defective (3.4 (b) (i))

Undertrays fitted obscuring some testable components

Nearside Headlamp aim too low (4.1.2 (a))

Offside Headlamp aim too low (4.1.2 (a))

Nearside Rear Tyre has a lump, caused by separation or partial failure of its structure Tread distorted/lumps on inner edge (5.2.3 (d) (ii)) DANGEROUS

Offside Rear Tyre has a lump, caused by separation or partial failure of its structure Tread distorted/lumps on inner edge (5.2.3 (d) (ii)) DANGEROUS

Nearside Front Tyre worn close to legal limit/worn on edge 2mm (5.2.3 (e))

Undertrays fitted obscuring some testable components

Front Registration plate does not conform to the specified requirements lettering to small (0.1 (d))

Nearside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Nearside Rear Floor excessively deteriorated within 30cm of mounting (6.2.4 (a) (i))

Nearside Rear Service brake effort inadequate at a wheel low effort (1.2.1 (a) (i))

Offside Headlamp aim too high (4.1.2 (a))

Rear Brakes imbalanced across an axle Axle 2 (1.2.1 (b) (i))

Catalyst Heat Shield Loose

Nearside Front Suspension arm pin or bush worn but not resulting in excessive movement arm bush front starting to spit (5.3.4 (a) (i))

Nearside Rear Subframe mounting prescribed area damaged but not considered excessive inner sill holed (inner rear arch) not affecting strength (5.3.6 (a) (i))

Nearside Rear Subframe mounting prescribed area is corroded but not considered excessive inner sill holed (inner rear arch) not affecting strength (5.3.6 (a) (i))

Offside Front Suspension arm pin or bush worn but not resulting in excessive movement arm bush front starting to spit (5.3.4 (a) (i))

Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

Rear Tyre slightly damaged/cracking or perishing on tread (5.2.3 (d) (ii))

cat converter heat sheild rattling

Front Registration plate does not conform to the specified requirements (0.1 (d))

Rear Registration plate does not conform to the specified requirements (0.1 (d))

Front Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

Exhaust has a minor leak of exhaust gases (7.1.2)

Rear Parking brake: parking brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.7)

Rear Service brake: service brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.7)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

fog lamp sl;ightly insecurely mounted