2001 Iveco Daily

Front Oil leak, but not excessive (8.4.1 (a) (i))

Nearside Front Vehicle structure is repaired but structural rigidity is not significantly reduced (6.1.1 (d) (i))

Nearside Rear Inner Integral body structure is repaired but structural rigidity is not significantly reduced (6.1.1 (d) (i))

Offside Front Vehicle structure is repaired but structural rigidity is not significantly reduced (6.1.1 (d) (i))

Offside Rear Inner Integral body structure is repaired but structural rigidity is not significantly reduced (6.1.1 (d) (i))

Offside Rear Tyre obviously under inflated (5.2.3 (l))

Rear Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

general corrosion underbody

Front Oil leak, but not excessive (8.4.1 (a) (i))

Nearside Front Vehicle structure is repaired but structural rigidity is not significantly reduced (6.1.1 (d) (i))

Nearside Headlamp aim too high (4.1.2 (a))

Nearside Rear Inner Integral body structure is repaired but structural rigidity is not significantly reduced (6.1.1 (d) (i))

Offside Front Vehicle structure is repaired but structural rigidity is not significantly reduced (6.1.1 (d) (i))

Offside Rear Inner Integral body structure is repaired but structural rigidity is not significantly reduced (6.1.1 (d) (i))

Offside Rear Tyre obviously under inflated (5.2.3 (l))

Rear Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

general corrosion underbody

Headlamp aim too high (4.1.2 (a))

Nearside Front Cab or chassis has excessive corrosion, seriously affecting its strength within 30cm of a cab mounting (6.2.2 (d) (i))

Nearside Rear Inner Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced (6.1.1 (c) (i))

Offside Front Cab or chassis has excessive corrosion, seriously affecting its strength within 30cm of a cab mounting (6.2.2 (d) (i))

Offside Rear Inner Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced (6.1.1 (c) (i))

Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Nearside Rear Parking (secondary brake) on a single line braking system has no recorded effort at a wheel (1.3.1 (a) (ii)) DANGEROUS

Parking brake efficiency less than 50% of the required value (1.4.2 (a) (ii)) DANGEROUS

Front Bumper mountings corroded but not likely to become detached (6.1.4 (a) (i))

Nearside Front Lower Suspension arm ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Nearside Rear Position lamp slightly affected by the operation of another lamp (4.2.3 (c))

Parking brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (1.4.2 (a) (i))

vehicle underside undercoated

Nearside Front Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Offside Front Headlamp aim too low (4.1.2 (a))

Offside Front Lower Seat belt anchorage prescribed area strength or continuity significantly reduced (7.1.1 (a) (i))

Offside Front Vehicle structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting (6.2.2 (d) (i))

Offside Rear Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced (6.1.1 (c) (i))

Front Bumper mountings corroded but not likely to become detached (6.1.4 (a) (i))

Nearside Front Lower Suspension arm ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Nearside Rear Position lamp slightly affected by the operation of another lamp (4.2.3 (c))

Parking brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (1.4.2 (a) (i))

Front Anti-roll bar pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Front Body panel slightly loose front panel (6.2.1 (a) (i))

Nearside Front Suspension arm ball joint has slight play (5.3.4 (a) (i))

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive inner arch (5.3.6 (a) (i))

Nearside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Front Body panel slightly loose wing (6.2.1 (a) (i))

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive inner arch (5.3.6 (a) (i))

Offside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Rear Oil leak, but not excessive diff (8.4.1 (a) (i))

Steering system slightly rough (2.1.1 (a))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Rear Brake load sensing valve linkage defective and function impaired (1.1.17 (a))

Service brake efficiency below requirements (1.2.2 (a) (i))

Front Anti-roll bar pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Front Body panel slightly loose front panel (6.2.1 (a) (i))

Nearside Front Suspension arm ball joint has slight play (5.3.4 (a) (i))

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive inner arch (5.3.6 (a) (i))

Nearside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Front Body panel slightly loose wing (6.2.1 (a) (i))

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive inner arch (5.3.6 (a) (i))

Offside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Rear Oil leak, but not excessive diff (8.4.1 (a) (i))

Steering system slightly rough (2.1.1 (a))

Nearside Front Hydraulic leak, but not excessive (8.4.1 (a) (i))

Offside Front Anti-roll bar pin or bush excessively worn dbush (5.3.4 (a) (i))

Offside Front Headlamp aim too low (4.1.2 (a))

Service brake efficiency below requirements (1.2.2 (a) (i))

Nearside Front Hydraulic leak, but not excessive (8.4.1 (a) (i))

Nearside Front Tyre worn close to legal limit/worn on edge outer edge worn (5.2.3 (e))

corrosion on battery tray , all secure at present

front subframe and suspension components corroded, ns side door inner step holed , osr inner wheel arch holed , all outer body outriggers holed , both rear inner cills holed

nsr inner cill holed all body out riggers holed ns inner door step holed

Battery insecure and likely to cause a short circuit (4.13 (a) (ii))

Offside Front Side repeater not working (4.4.1 (a) (ii))

Rear Registration plate lamp inoperative in the case of a single lamp or all lamps both (4.7.1 (b) (ii))

Service brake efficiency below requirements (1.2.2 (a) (i))

Offside Front Brake master cylinder/servo mounting prescribed area is excessively corroded and functionality of the braking system is affected (1.1.21 (e) (ii)) DANGEROUS

Brake fluid warning lamp illuminated (1.1.10 (f))

Nearside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

nsr inner cill large hole all body out riggers holed oil leak

Front Anti-roll bar linkage rubber mounting deteriorated but not resulting in excessive movement both D bushes (2.4.G.2)

osr inner wheel arch holed

Exhaust has a major leak of exhaust gases front pipe not sealed (7.1.2)

Offside Front Inner Brake master cylinder/servo mounting prescribed area is excessively corroded wheel arch (3.6.C.3)

Front Anti-roll bar linkage rubber mounting deteriorated but not resulting in excessive movement both D bushes (2.4.G.2)

osr inner wheel arch holed

Offside Rear rear body outrigger holed

corrosion on chassis and suspension components

ns panel under door step holed

Brake hose stretched (found during steering lock to lock check) catching on tyre on lock to lock (2.2.D.2b)

Exhaust has a major leak of exhaust gases several blows (7.1.2)

Nearside Rear Rear position lamp(s) not working (1.1.A.3b)

Offside Front Lower Seat belt anchorage prescribed area is excessively corroded under van on out rigger (5.2.6)

Parking brake: efficiency below requirements (3.7.B.7)

Service brake: efficiency below requirements (3.7.B.7)

Tyre tread depth below requirements of 1.6mm both rear (4.1.E.1)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Rear rear body outrigger holed

all 4 tyres sidewalls cracking

corrosion on chassis and suspension components

ns panel under door step holed

Front Lower Suspension arm has slight play in a ball joint (2.4.G.2)

General corrosion to vehicle body,chassis and components

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Rear brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

front tyres wearing on edges

Brakes imbalanced across an axle (3.7.B.5b)

Service brake: efficiency below requirements (3.7.B.7)

Front Lower Suspension arm has slight play in a ball joint (2.4.G.2)

General corrosion to vehicle body,chassis and components

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

front tyres wearing on edges

Nearside Front Body has a projection caused by corrosion (6.1.C.1)

Nearside Front Sub-frame corroded and seriously weakened (2.4.G.1)

Offside Front Body has a projection caused by corrosion (6.1.C.1)

Offside Front Sub-frame corroded and seriously weakened (2.4.G.1)

Offside Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Front Lower Suspension arm has slight play in a ball joint (2.4.G.2)

Front Sub-frame corroded but not seriously weakened (2.4.G.1)

General corrosion to chassis body and components

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Offside Rear Direction indicators slightly discoloured (1.4.A.2f)

Rear brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

n/s/f tyre outer edge wearing

Brake load sensing valve seized (3.6.E.3)

Nearside Front Brake pipe excessively corroded (3.6.B.2c)

Nearside Rear Anti-roll bar has excessive play in a pin/bush (2.4.G.2)

Nearside Rear Brake pipe excessively corroded (3.6.B.2c)

Nearside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Front Brake pipe excessively corroded (3.6.B.2c)

Offside Rear Anti-roll bar has excessive play in a pin/bush (2.4.G.2)

Offside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Parking brake: efficiency below requirements (3.7.B.7)

Service brake: efficiency below requirements (3.7.B.7)

Offside Inner Front Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Service brake: efficiency below requirements (3.7.B.7)

Parking brake: parking brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.7)

Nearside Front Brake pipe slightly corroded (3.6.B.2c)

Offside Front Brake pipe slightly corroded (3.6.B.2c)

Brake pedal creeps down while the pedal is held under pressure (3.3.B.1a)

Exhaust has part of the system excessively deteriorated (7.1.1a)

Nearside Front position lamp(s) not working (1.1.A.3b)

Nearside Rear Tyre has ply or cords exposed (4.1.D.1b)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Rear Anti-roll bar rubber bush deteriorated resulting in excessive movement (2.4.G.2)

Rear brake disc excessively pitted (3.5.1h)

Parking brake: efficiency below requirements (3.7.B.7) DANGEROUS

Service brake: efficiency below requirements (3.7.B.7) DANGEROUS

Front Lower Suspension arm has slight play in a ball joint (2.4.G.2)