2008 Mercedes-benz Vito

Nearside Front Integral body structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Offside Rear Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Rear Coil spring corroded both side (5.3.1 (b) (i))

Rear Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Windscreen damaged but not adversely affecting driver's view (3.2 (a) (i))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Central Front Exhaust mounting defective (6.1.2 (a))

Nearside Front Inner Vehicle structure is corroded but structural rigidity is not significantly reduced seal (6.1.1 (c) (i))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Rear Tyre worn close to legal limit/worn on edge on 1.6 mm (5.2.3 (e))

Offside Rear Vehicle structure or chassis corroded within 30cm of a mounting, but not seriously affecting overall security (6.2.2 (d) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Rear Coil spring corroded both side (5.3.1 (b) (i))

Windscreen damaged but not adversely affecting driver's view (3.2 (a) (i))

Windscreen damaged but not adversely affecting driver's view (3.2 (a) (i))

Nearside Rear Tyre worn close to legal limit/worn on edge on 1.6 mm (5.2.3 (e))

Offside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Front Position lamp not working (4.2.1 (a) (ii))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Nearside Front Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (1.2.1 (b) (i))

number plate lamp not working

surface corrosion on underside

Brake lever has insufficient reserve travel (1.1.2 (a))

Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))

Parking brake efficiency less than 50% of the required value (1.4.2 (a) (ii)) DANGEROUS

number plate lamp not working

surface corrosion on underside

Offside Headlamp has a product on the lens but not seriously reducing light output (4.1.4 (b))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Rear Tyre worn close to legal limit/worn on edge down to 3mm (5.2.3 (e))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Rear Tyre worn close to legal limit/worn on edge down to 3mm (5.2.3 (e))

Offside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Front Brake pad(s) wearing thin x 2 (3.5.1g)

Nearside Front Headlamp not working on dipped beam (1.7.5a)

Offside Front Exhaust system not adequately supported (7.1.1)

Nearside Stop lamp not working (1.2.1b)

Offside Stop lamp not working (1.2.1b)

Supplementary Restraint System warning lamp indicates a fault (5.4.2)

Nearside Front Anti-roll bar has slight play in a pin/bush (2.4.G.2)