2006 Toyota Aygo

Front Headlamp lens slightly defective Both (4.1.1 (b) (i))

General corrosion to underbody and suspension components

Nearside Rear Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Nearside Rear Service brake binding but not excessively (1.2.1 (f))

Nearside Rear tyre pressure was low (adjusted back to 30psi)

Nearside welding repairs to nearside floor to inner sill

Offside Front Wheel bearing slightly noisy (5.1.3 (b) (i))

Parking brake lever has no reserve travel

Rear Shock absorbers has a slightly worn bush Both lower bushes are slightly perished (5.3.2 (c))

Rear previous welding repairs (by rear axle mounting points)

Nearside Vehicle structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting floor to inner sill corroded (6.2.2 (d) (i))

Front Headlamp lens slightly defective Both (4.1.1 (b) (i))

General corrosion to underbody and suspension components

Nearside Rear Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Nearside Rear Service brake binding but not excessively (1.2.1 (f))

Nearside Rear tyre pressure was low (adjusted back to 30psi)

Offside Front Wheel bearing slightly noisy (5.1.3 (b) (i))

Parking brake lever has no reserve travel

Rear Shock absorbers has a slightly worn bush Both lower bushes are slightly perished (5.3.2 (c))

Rear previous welding repairs (by rear axle mounting points)

Underbody and suspension undersealed

Offside Front Headlamp has a product on the lens but not seriously reducing light output (4.1.4 (b))

Underbody and suspension undersealed

Horn not working (7.7 (a))

Nearside Rear Service brake excessively binding (1.2.1 (f))

Offside Front Headlamp levelling device inoperative (4.1.5 (a))

Rear Brakes imbalanced across an axle (1.2.1 (b) (i))

Offside Front Headlamp has a product on the lens but not seriously reducing light output (4.1.4 (b))

Underbody and suspension undersealed

Front Headlamp has a product on the lens but not seriously reducing light output Both sides (4.1.4 (b))

Rear Brake pipe corroded, covered in grease or other material All pipes (1.1.11 (c))

Rear Coil spring corroded Both sides (5.3.1 (b) (i))

Rear Exhaust shield missing

Nearside Rear Seat belt anchorage prescribed area strength or continuity significantly reduced (7.1.1 (a) (i))

Nearside Rear Seat belt anchorage prescribed area strength or continuity significantly reduced (7.1.1 (a) (i))

Offside Rear Seat belt anchorage prescribed area strength or continuity significantly reduced (7.1.1 (a) (i))

Nearside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Rear Seat belt anchorage prescribed area is corroded but not considered excessive (7.1.1 (a) (i))

Rear Coil spring corroded Both sides (5.3.1 (b) (i))

Rear Exhaust shield missing

Nearside Rear Inner Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill (5.3.6 (a) (i))

Nearside Rear Outer Seat belt anchorage prescribed area strength or continuity significantly reduced sill marked (7.1.1 (a) (i))

Nearside Front Lower Suspension arm pin or bush worn but not resulting in excessive movement rear bush (5.3.4 (a) (i))

Nearside Rear Brake pipe corroded, covered in grease or other material far most (1.1.11 (c))

Offside Front Lower Suspension arm pin or bush worn but not resulting in excessive movement rear bush (5.3.4 (a) (i))

Offside Rear Brake pipe corroded, covered in grease or other material far most (1.1.11 (c))

Offside Rear Outer Seat belt anchorage prescribed area is corroded but not considered excessive sill/slight weak/corroded (7.1.1 (a) (i))

Rear Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Rear Seat belt anchorage prescribed area is corroded but not considered excessive floor pan & nearside inner sills and offside inner sills (7.1.1 (a) (i))

exhaust heat shield missing around fuel tank missing but not close to any fuel componnets

Front Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (1.2.1 (b) (i))

Front Lower Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Nearside Rear Service brake binding but not excessively (1.2.1 (f))

Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Rear Suspension component mounting prescribed area is corroded but not considered excessive axle mounts both sides (5.3.6 (a) (i))

Rear heat shield by fuel tank insecure ,

Brake pad(s) wearing thin (1.1.13 (a) (ii))

Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Nearside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Exhaust has a major leak of exhaust gases (6.1.2 (a))

Nearside Headlamp not working on dipped beam (4.1.1 (a) (ii))

Offside Position lamp not working (4.2.1 (a) (ii))

Windscreen washer provides insufficient washer liquid (3.5 (a))

Brake pad(s) wearing thin (1.1.13 (a) (ii))

Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Nearside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Emissions fluctuating ? Passed ok

Nearside Front Suspension arm ? Rear bush has slight wear

Nearside Front Headlamp aim too low (1.8)

Exhaust has a minor leak of exhaust gases (7.1.2)

Offside Rear tyre starting to crack/perish between tread

Exhaust emissions Lambda reading after 2nd fast idle outside specified limits (7.3.D.3)

Exhaust has a minor leak of exhaust gases corroded (7.1.2)

Offside Rear tyre starting to crack/perish between tread

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)