2008 Peugeot 107

Battery insecure but not likely to fall from carrier (4.13 (a) (i))

Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement Both (5.3.4 (a) (i))

Front Brake disc worn, pitted or scored, but not seriously weakened Both (1.1.14 (a) (ii))

Front Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Front Tyre slightly damaged/cracking or perishing Both (5.2.3 (d) (ii))

Nearside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside Rear Tyre has a cut but not deep enough to reach the ply or cords (5.2.3 (d) (i))

Offside Rear Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Oil leak, but not excessive (8.4.1 (a) (i))

Rear Axle corroded

Rear Coil spring corroded Both (5.3.1 (b) (i))

Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))

Front Headlamp aim projected beam image is obviously incorrect Both (4.1.2 (c))

Nearside Rear Parking brake inoperative on one side (1.4.1 (a))

Nearside Rear Service brake excessively binding (1.2.1 (f))

Offside Front Suspension arm pin or bush excessively worn Rear bush (5.3.4 (a) (i))

Offside Rear Outer Suspension component mounting prescribed area excessively corroded significantly reducing structural strength Sill (5.3.6 (a) (i))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Rear Brakes imbalanced across an axle Axle 2 (1.2.1 (b) (i))

Battery insecure but not likely to fall from carrier (4.13 (a) (i))

Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement Both (5.3.4 (a) (i))

Front Brake disc worn, pitted or scored, but not seriously weakened Both (1.1.14 (a) (ii))

Front Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Front Tyre slightly damaged/cracking or perishing Both (5.2.3 (d) (ii))

Nearside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside Rear Tyre has a cut but not deep enough to reach the ply or cords (5.2.3 (d) (i))

Offside Rear Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Oil leak, but not excessive (8.4.1 (a) (i))

Rear Axle corroded

Rear Coil spring corroded Both (5.3.1 (b) (i))

Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Front Service brake fluctuating, but not excessively (1.2.1 (e))

Front Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Offside Front Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Offside Rear Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

reversing lamp not working

Emissions unable to be completed due to exhaust leak (8.2.1.2 (d))

Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))

Front Exhaust has a major leak of exhaust gases (6.1.2 (a))

Nearside Headlamp aim too low (4.1.2 (a))

Nearside Rear Service brake excessively binding (1.2.1 (f))

Rear Exhaust has a major leak of exhaust gases box (6.1.2 (a))

Rear fog lamp not working (4.5.1 (a) (ii))

Central Exhaust mounting defective (6.1.2 (a))

Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Front Service brake fluctuating, but not excessively (1.2.1 (e))

Front Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Offside Front Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Offside Rear Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

reversing lamp not working

Battery insecure but not likely to fall from carrier (4.13 (a) (i))

Central Front Exhaust mounting defective (6.1.2 (a))

Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Front Bumper mountings corroded but not likely to become detached (6.1.4 (a) (i))

Front Service brake fluctuating, but not excessively (1.2.1 (e))

Front Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Nearside Rear Service brake binding but not excessively (1.2.1 (f))

Offside Front Lower Suspension arm pin or bush worn but not resulting in excessive movement inner / rear (5.3.4 (a) (i))

Front Bumper mountings corroded but not likely to become detached (6.1.4 (a) (i))

Nearside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Emissions not tested (8.2.1.2 (d))

Nearside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (5.2.3 (d) (i))

Offside Rear Brake pipe excessively corroded (1.1.11 (c))

Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Nearside Front Tyre has ply or cords damaged (5.2.3 (d) (ii)) DANGEROUS

Parking brake efficiency less than 50% of the required value (1.4.2 (a) (ii)) DANGEROUS

Front Bumper mountings corroded but not likely to become detached (6.1.4 (a) (i))

Nearside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))

Exhaust carbon monoxide content after 2nd fast idle exceeds manufacturer's specified limits (8.2.1.2 (a))

Front Lower Suspension arm pin or bush excessively worn both rear bushes (5.3.4 (a) (i))

Nearside Front Road wheel badly distorted (5.2.2 (c) (i))

Nearside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Wheel bearing slightly noisy both rear (5.1.3 (b) (i))

o/s/f lower rear suspension bush badly worn

o/s/f tyre badly worn

Front registration plate character(s) likely to be misread (6.3.4b)

Offside Front Front position lamp(s) not working (1.1.A.3b)

o/s/f lower rear suspension bush badly worn

o/s/f tyre badly worn

ENGINE MANAGEMENT LIGHT ON

Front Anti-roll bar linkage rubber mounting deteriorated but not resulting in excessive movement BOTH (2.4.G.2)

Nearside Rear Road wheel with a slightly distorted bead rim (4.2.A.1a)

Offside Front Lower Suspension arm synthetic bush deteriorated but not resulting in excessive movement REAR BUSH (2.4.G.2)

Offside Front Shock absorber has slight corrosion to the casing (2.7.2a)

Rear BOTH REAR AXLE BUSHES PERISHING

Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Front Windscreen wiper does not clear the windscreen effectively (8.2.2)

Front brake disc in such a condition that it is seriously weakened (3.5.1i)

Nearside Front Front position lamp(s) not working (1.1.A.3b)

ENGINE MANAGEMENT LIGHT ON

Front Anti-roll bar linkage rubber mounting deteriorated but not resulting in excessive movement BOTH (2.4.G.2)

Nearside Rear Road wheel with a slightly distorted bead rim (4.2.A.1a)

Offside Front Lower Suspension arm synthetic bush deteriorated but not resulting in excessive movement REAR BUSH (2.4.G.2)

Offside Front Shock absorber has slight corrosion to the casing (2.7.2a)

Rear BOTH REAR AXLE BUSHES PERISHING

EML shows a fault

Front Inner Brake pad(s) wearing thin (3.5.1g)

Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

EML shows a fault

Front Inner Brake pad(s) wearing thin (3.5.1g)

Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Windscreen wiper does not clear the windscreen effectively (8.2.2)

both front tyres badly worn

Oil leak

Nearside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Nearside Registration plate lamp not working (1.1.C.1d)

Offside Front Lower Suspension arm rubber bush bonding deteriorated resulting in excessive movement (2.4.G.2)

Nail in nearside rear tyre

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Oil leak

Windscreen wiper slightly smears windscreen

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Headlamp aim beam image obviously incorrect (1.8.A.1b)

Offside Headlamp aim too high (1.8)

Offside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Offside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Parking brake lever has no reserve travel (3.1.6b)

Windscreen wiper does not clear the windscreen effectively (8.2.2)

Service brake: service brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.7)

rear exhaust rubber perished

Nearside Headlamp not working on dipped beam (1.7.5a)