2004 Mazda B Series

Brake load sensing valve linkage defective and function impaired (1.1.17 (a))

Offside Front Service brake excessively fluctuating (1.2.1 (e))

Suspension component mounting prescribed area excessively corroded significantly reducing structural strength nearside front inner wheel arch (5.3.6 (a) (i))

Windscreen wiper does not clear the windscreen effectively both (3.4 (b) (ii))

Brake load sensing valve stiff (1.1.17 (c) (ii))

Brake pipe excessively corroded both front to rear (1.1.11 (c))

Exhaust has a major leak of exhaust gases (6.1.2 (a))

Nearside Seat belt anchorage prescribed area strength or continuity significantly reduced outer sill marked in yellow (7.1.1 (a) (i))

Offside Front Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Brake load sensing valve stiff (1.1.17 (c) (ii))

Offside Rear Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Brake pipe corroded, covered in grease or other material both front to rear (1.1.11 (c))

Offside Front Anti-roll bar pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Anti-roll bar has slight play in a pin/bush Both front d bushes (2.4.G.2)

Brake pipe slightly corroded All rear around compensator (3.6.B.2c)

Brake pipe slightly corroded Both front to rear (3.6.B.2c)

Tyre worn close to the legal limit Both Rear (4.1.E.1)

Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Nearside Front brake caliper securing device excessively deteriorated Top slider (3.5.1j)

Offside Front Upper Suspension arm has excessive play in a pin/bush (2.4.G.2)

Anti-roll bar has slight play in a pin/bush Both front d bushes (2.4.G.2)

Brake pipe slightly corroded All rear around compensator (3.6.B.2c)

Brake pipe slightly corroded Both front to rear (3.6.B.2c)

Tyre worn close to the legal limit Both Rear (4.1.E.1)

Nearside Front Windscreen wiper does not clear the windscreen effectively (8.2.2)

Offside Front Windscreen wiper does not clear the windscreen effectively (8.2.2)

Front Brake pad(s) wearing thin (3.5.1g)

Brake load sensing valve seized (3.6.E.3)

Front Brake pad(s) wearing thin (3.5.1g)

Prop-shaft universal joint worn

n/s/f tyre wearing inner edge

Centre Exhaust system not adequately supported (7.1.1)

Nearside Inner Front Upper Suspension arm rubber bush deteriorated resulting in excessive movement (2.4.G.2)

n/s/f tyre wearing inner edge

Front Anti-roll bar rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Spare tyre low on tread

Nearside Front Seat belt locking mechanism does not secure or release (5.2.5a)

Front Anti-roll bar rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Headlamp aim too high (1.8)

Spare tyre low on tread

Nearside Front Brake pipe excessively corroded (3.6.B.2c)

Offside Front Brake pipe excessively corroded (3.6.B.2c)

Offside Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Nearside Headlamp aim too low (1.8)

nsf tyre wearing on inner edge

Brake pipe excessively corroded (3.6.B.2c)

Shock absorber has an excessively worn bush (2.7.4)

Nearside Front Lower Shock absorber has a slightly worn bush (2.7.4)

Offside Front Lower Shock absorber has a slightly worn bush (2.7.4)