2008 Ford Ka

Nearside Front Headlamp not working on dipped beam (4.1.1 (a) (ii))

Nearside Front Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Nearside Outer Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced outer sill badly corroded front and middle (6.1.1 (c) (i))

Offside Front Outer Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced outer sill corroded front and middle (6.1.1 (c) (i))

Offside Front Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Rear Exhaust system insecure back box steel hanger snapped and corroded (6.1.2 (a))

Offside Front Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

both front top strut bearings rough but no play and secure

clutch hydraulic system faulty not fully disengaging

fuel filler cap and pipe badly corroded

Nearside Suspension component mounting prescribed area is corroded but not considered excessive inner/outer sill (5.3.6 (a) (i))

Nearside Suspension component mounting repair covered in underseal inner/outer sill (5.3.6 (a) (i))

Offside Suspension component mounting prescribed area is corroded but not considered excessive inner /outer sill (5.3.6 (a) (i))

Suspension component mounting prescribed area is corroded but not considered excessive both rear inner wheel arches corroded (5.3.6 (a) (i))

Suspension component mounting repair covered in underseal inner/outer sill (5.3.6 (a) (i))

Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Exhaust has a major leak of exhaust gases catalitic converter (6.1.2 (a))

Nearside Inner Seat belt anchorage prescribed area strength or continuity significantly reduced sill (7.1.1 (a) (i))

Nearside Outer Seat belt anchorage prescribed area strength or continuity significantly reduced (7.1.1 (a) (i))

Offside Inner Seat belt anchorage prescribed area strength or continuity significantly reduced sill (7.1.1 (a) (i))

Offside Outer Seat belt anchorage prescribed area strength or continuity significantly reduced (7.1.1 (a) (i))

Nearside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Nearside Front Integral body structure or chassis corroded within 30cm of a mounting, but not seriously affecting overall security (6.2.2 (d) (i))

Offside Front Integral body structure or chassis corroded within 30cm of a mounting, but not seriously affecting overall security (6.2.2 (d) (i))

Nearside Rear Shock absorbers has a serious fluid leak (5.3.2 (b))

Offside Front Seat belt anchorage prescribed area strength or continuity significantly reduced (7.1.1 (a) (i))

Parking brake efficiency less than 50% of the required value (1.4.2 (a) (ii)) DANGEROUS

Front Exhaust mounting defective (6.1.2 (a))

Nearside Front Integral body structure or chassis corroded within 30cm of a mounting, but not seriously affecting overall security (6.2.2 (d) (i))

Offside Front Integral body structure or chassis corroded within 30cm of a mounting, but not seriously affecting overall security (6.2.2 (d) (i))

Central Front Exhaust system not adequately supported (7.1.1)

Front Brakes imbalanced across an axle Axle 1 (3.7.B.5b)

Nearside Rear Sub-frame has excessive play in a pin/bush (2.4.G.2)

Offside Rear Sub-frame ball joint dust cover excessively damaged so that it no longer prevents the ingress of dirt (2.4.G.2)

Offside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Offside Front Lower Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)