2006 Toyota Aygo

Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Headlamp has a product on the lens but not seriously reducing light output both (4.1.4 (b))

Integral body structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Rear Brake pipe corroded, covered in grease or other material both sides (1.1.11 (c))

Brake pipe corroded, covered in grease or other material Both nearside and offside rear (1.1.11 (c))

Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Nearside Front Service brake binding but not excessively (1.2.1 (f))

Nearside Rear Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Rear Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))

Suspension component mounting prescribed area is corroded but not considered excessive Both nearside and offside rear (5.3.6 (a) (i))

Nearside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Offside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Offside Front Lower Suspension arm pin or bush worn but not resulting in excessive movement rear (5.3.4 (a) (i))

Offside Front Lower Suspension arm pin or bush worn but not resulting in excessive movement rear (5.3.4 (a) (i))

Rear Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Stop lamp(s) switch does not operate in accordance with the requirements all (4.3.2 (a) (i))

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Nearside Front Position lamp not working (4.2.1 (a) (ii))

Nearside Rear Outer Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill (5.3.6 (a) (i))

Nearside Rear Position lamp adversely affected by the operation of another lamp (4.2.3 (c))

Nearside Rear Stop lamp(s) adversely affected by the operation of another lamp (4.3.3 (b))

Offside Front Outer Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Offside Front Position lamp not working (4.2.1 (a) (ii))

Offside Rear Position lamp adversely affected by the operation of another lamp (4.2.3 (c))

Offside Rear Stop lamp(s) adversely affected by the operation of another lamp (4.3.3 (b))

Registration plate lamp inoperative in the case of a single lamp or all lamps both (4.7.1 (b) (ii))

Rear Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Front exhaust hanger broken but exhaust still secure

Nearside Front Tyre worn close to legal limit/worn on edge No visible tread on either edge and rest of tyre on 2mm (5.2.3 (e))

Nearside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Front Tyre worn close to legal limit/worn on edge No visible tread on inner edge (5.2.3 (e))

Exhaust emissions likely to be affected by an exhaust leak Pipe into rear box blowing at hanger joint (8.2.2.1 (b))

Nearside Rear Wheel bearing rough when rotated (5.1.3 (b) (i))

Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Front exhaust hanger broken but exhaust still secure

Nearside Front Tyre worn close to legal limit/worn on edge No visible tread on either edge and rest of tyre on 2mm (5.2.3 (e))

Nearside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Front Tyre worn close to legal limit/worn on edge No visible tread on inner edge (5.2.3 (e))

Nearside Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Front Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii)) DANGEROUS

Offside Rear Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Front Service brake fluctuating, but not excessively (1.2.1 (e))

Nearside Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

temporary fuel cap fitted

temporey

Front tyres are starting to wear.

Nearside Rear /and offside exhaust back box support rubbers deteriorated.

Offside Front Inner Road wheel with a slightly distorted bead rim (4.2.A.1a)

Nearside Headlamp aim too high (1.8)

Nearside Rear /and offside exhaust back box support rubbers deteriorated.

Offside Front Inner Road wheel with a slightly distorted bead rim (4.2.A.1a)

Offside Headlamp aim too high (1.8)

Nearside Front Lower Macpherson strut corroded but not seriously weakened (2.4.G.1)

Nearside Front Tie bar/rod rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Front Lower Macpherson strut corroded but not seriously weakened (2.4.G.1)

Offside Front Tie bar/rod rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Nail in nearside front tyre

rear exhaust mounting rubber perished

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Coolant leak

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)