2013 Hyundai I10

Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))

Nearside Rear Service brake excessively fluctuating (1.2.1 (e))

Offside Front Service brake excessively fluctuating (1.2.1 (e))

Offside Front Suspension arm pin or bush excessively worn (5.3.4 (a) (i))

Offside Headlamp aim too low (4.1.2 (a))

Offside Rear Service brake lagging in operation (1.2.1 (d))

Windscreen washer provides insufficient washer liquid (3.5 (a))

Nearside Rear Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Offside Rear Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Front Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Nearside Rear Coil spring corroded (5.3.1 (b) (i))

Offside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Rear Coil spring corroded (5.3.1 (b) (i))

Offside Rear Shock absorbers has a reduced damping effect (5.3.2 (d))

Oil leak, but not excessive (8.4.1 (a) (i))

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Nearside Front Position lamp not working (4.2.1 (a) (ii))

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Offside Front Position lamp not working (4.2.1 (a) (ii))

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Nearside Front Suspension arm ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Brake pipe corroded, covered in grease or other material both center main (1.1.11 (c))

Front Windscreen washer provides insufficient washer liquid (3.5 (a))

Front Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Nearside Front Headlamp not working on dipped beam (4.1.1 (a) (ii))

Offside Front Suspension arm ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Offside Front Suspension arm ball joint excessively worn (5.3.4 (a) (i))

Brake pipe corroded, covered in grease or other material both center main (1.1.11 (c))

Offside Front Brake disc worn, pitted or scored, but not seriously weakened signs of over heating (1.1.14 (a) (ii))

Offside Front Service brake binding but not excessively (1.2.1 (f))

Nearside Front Tyre slightly damaged (5.2.3 (d) (ii))

Offside Front Suspension arm ball joint has slight play (5.3.4 (a) (i))

Offside Front Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))

Nearside Front Position lamp not working (4.2.1 (a) (ii))

Offside Front Headlamp levelling device inoperative (4.1.5 (a))

Nearside Front Tyre slightly damaged (5.2.3 (d) (ii))

Offside Front Suspension arm ball joint has slight play (5.3.4 (a) (i))

Offside Front Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))

Nearside Rear Brake pipe corroded, covered in grease or other material cyl (1.1.11 (c))

Brake pipe excessively corroded both rear main (1.1.11 (c))

Nearside Front Position lamp not working (4.2.1 (a) (ii))

Nearside Rear Stop lamp(s) not working (4.3.1 (a) (ii))

Offside Rear Brake pipe excessively corroded cyl (1.1.11 (c))

Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Tyre has a cut in excess of the requirements deep enough to reach the ply or cords both rear (5.2.3 (d) (i))

Front Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii)) DANGEROUS

Brake disc worn, pitted or scored, but not seriously weakened both front signs of over heating (1.1.14 (a) (ii))

Nearside Rear Brake pipe corroded, covered in grease or other material cyl (1.1.11 (c))

Brake pipe corroded, covered in grease or other material both rear main (1.1.11 (c))

Offside Front Position lamp not working (4.2.1 (a) (ii))

Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Brake pipe corroded, covered in grease or other material both rear main (1.1.11 (c))

Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Nearside Rear Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Offside Front Service brake binding but not excessively (1.2.1 (f))

Nearside Front Service brake binding but not excessively (1.2.1 (f))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Position lamp not working both front (4.2.1 (a))

Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Offside Front Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Nearside Front Service brake binding but not excessively (1.2.1 (f))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))