1993 Rover 216

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

nsf tyre side wall damage

Nearside Front Tyre(s) incorrect because different size tyres are fitted on the same axle. (4.1.A.1a)

Nearside Outer Seat belt anchorage prescribed area is inadequately repaired (5.2.6)

Nearside Rear Tyre has a tear, caused by separation or partial failure of its structure (4.1.D.1b)

Offside Front Headlamp aim too low (1.8)

Offside Front Tyre(s) incorrect because different size tyres are fitted on the same axle. (4.1.A.1a)

Offside Lower Front suspension locking device missing (2.5.A.4)

Offside Outer Seat belt anchorage prescribed area is inadequately repaired (5.2.6)

Offside rear parking brake recording little or no effort (3.7.B.6a)

Nearside Front Anti-roll bar linkage rubber mounting deteriorated but not resulting in excessive movement (2.4.G.2)

Nearside Front Subframe mounting prescribed area is distorted but not considered excessive (2.4.A.3)

Nearside Front suspension has slight play in a lower suspension ball joint (2.5.B.1a)

Nearside Rear Anti-roll bar linkage has slight play in a pin/bush (2.4.G.2)

Nearside Rear Brake lining(s) wearing thin (3.5.1g)

Offside Front Anti-roll bar linkage rubber mounting deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Rear Anti-roll bar linkage has slight play in a pin/bush (2.4.G.2)

Offside Rear Brake lining(s) wearing thin (3.5.1g)

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

cut in nsf tyre

Engine/gearbox mounting(s) defective

Nearside Front Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Nearside Rear Suspension arm rubber bush deteriorated resulting in excessive movement (2.4.G.2)

Nearside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Nearside Windscreen washer provides insufficient washer liquid (8.2.3)

Offside Rear Suspension arm rubber bush deteriorated resulting in excessive movement (2.4.G.2)

Offside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)