2007 Smart (mcc) Fortwo Coupe

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Nearside Front Outer Track rod end ball joint has slight play (2.1.3 (b) (i))

Nearside Rear Service brake binding but not excessively (1.2.1 (f))

Nearside Rear Brake pipe corroded, covered in grease or other material Slightly corroded (1.1.11 (c))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Rear Brake pipe corroded, covered in grease or other material Slightly corroded (1.1.11 (c))

Nearside Front Shock absorbers light misting of oil or has limited damping effect (5.3.2 (b))

Nearside Front Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Offside Front Shock absorbers light misting of oil or has limited damping effect (5.3.2 (b))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Front Windscreen washer provides insufficient washer liquid (3.5 (a))

Nearside Front Anti-roll bar linkage fractured (5.3.3 (b) (ii)) DANGEROUS

Nearside Front Shock absorbers light misting of oil or has limited damping effect (5.3.2 (b))

Nearside Front Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Offside Front Shock absorbers light misting of oil or has limited damping effect (5.3.2 (b))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Front Coil spring fractured or broken (5.3.1 (b) (i))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Headlamp aim too low (1.8)

Nearside Rear Wheel bolt(s) loose (4.2.A.1e)

Body has slight corrosion under body (6.1.B.2)

Front Suspension arm ball joint dust cover deteriorated, but preventing the ingress of dirt both sides (2.4.G.2)

Engine covers fitted obscuring some components in the engine bay

Exhaust system not adequately supported (7.1.1)

Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)