2004 Honda Jazz

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Nearside Front Headlamp has a product on the lens but not seriously reducing light output (4.1.4 (b))

Offside Front Headlamp has a product on the lens but not seriously reducing light output (4.1.4 (b))

Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

Rear Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

fuel filler pipe corroded

Nearside Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Tyre tread depth below requirements of 1.6mm Both front (5.2.3 (e)) DANGEROUS

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

Rear Registration plate deteriorated but not likely to be misread (0.1 (b))

Emissions not tested (8.2.1.2 (d))

Engine MIL inoperative or indicates a malfunction (8.2.2.2 (g))

Exhaust has a major leak of exhaust gases (6.1.2 (a))

Offside Front Anti-roll bar ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Service brake efficiency below requirements (1.2.2 (a) (i))

Nearside Front Suspension arm pin or bush likely to become detached (5.3.4 (a) (ii)) DANGEROUS

Offside Front Suspension arm pin or bush likely to become detached (5.3.4 (a) (ii)) DANGEROUS

Rear Registration plate deteriorated but not likely to be misread (0.1 (b))

Exhaust has a minor leak of exhaust gases (7.1.2)

Nearside Front Tyre worn close to the legal limit inner/outer (4.1.E.1)

Offside Front Tyre worn close to the legal limit inner/outer (4.1.E.1)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Nearside Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Offside Brake pipe slightly corroded (3.6.B.2c)

Offside Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Offside Rear Brake pipe slightly corroded (3.6.B.2c)

Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)