2005 Toyota Aygo

Nearside Front Steering locking device missing (2.1.3 (d))

Nearside Rear Vehicle structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting Hole in n/s/r sill, within 30cm of rear subframe mount. (6.2.2 (d) (i))

Offside Front Steering locking device missing (2.1.3 (d))

Offside Front Vehicle structure is fractured and structural rigidity is significantly reduced Floor pan fractured, within 30cm of front subframe mount. (6.1.1 (a) (i))

Air/vacuum reservoir has minor corrosion Brake Servo (1.1.9 (a) (i))

Front Windscreen wiper blade defective (3.4 (b) (i))

Nearside Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Front Lower Bottom ball joint locking device missing

Nearside Rear Service brake binding but not excessively (1.2.1 (f))

Nearside Headlamp aim too high (4.1.2 (a))

Offside Headlamp aim too high (4.1.2 (a))

Headlamp lens slightly defective both lamps (4.1.1 (b) (i))

Rear Brake pipe corroded, covered in grease or other material both pipes (1.1.11 (c))

Rear Brake pipe corroded, covered in grease or other material both pipes (1.1.11 (c))

Brake servo corroded but not excessively weakened (3.6.A.2b)

Front brake disc worn, pitted or scored, but not seriously weakened both discs (3.5.1i)

Front brake disc worn, pitted or scored, but not seriously weakened both discs (3.5.1i)

Headlamp aim too low both lamps (1.8)

Nearside Rear Shock absorber has slight corrosion to the casing (2.7.2a)

Nearside Rear coil spring corroded (2.4.C.1b)

Offside Rear Shock absorber has slight corrosion to the casing (2.7.2a)

Offside Rear coil spring corroded (2.4.C.1b)

both rear tyres very slightly perished in tread area

lots of surface corrosion to underside and to major components

exhaust mountings heavily corroded

Front Windscreen wiper does not clear the windscreen effectively (8.2.2)

Hazard warning switch faulty (1.4.B.1d)

exhaust mountings heavily corroded