2008 Mercedes-benz Vito

Nearside Front Anti-roll bar ball joint has slight play (5.3.4 (a) (i))

Front Oil leak, but not excessive crankshaft oil seal (8.4.1 (a) (i))

Nearside Front Anti-roll bar linkage ball joint has slight play (5.3.4 (a) (i))

Offside Front Brake pipe corroded, covered in grease or other material on bulkhead (1.1.11 (c))

Offside Rear Wheel bearing slightly noisy (5.1.3 (b) (i))

Offside Front Lower Suspension arm ball joint excessively worn (5.3.4 (a) (i))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Front Oil leak, but not excessive crankshaft oil seal (8.4.1 (a) (i))

Nearside Front Anti-roll bar linkage ball joint has slight play (5.3.4 (a) (i))

Offside Front Brake pipe corroded, covered in grease or other material on bulkhead (1.1.11 (c))

Offside Rear Wheel bearing slightly noisy (5.1.3 (b) (i))

Offside Front Brake pipe corroded, covered in grease or other material at bulkhead (1.1.11 (c))

Offside Front Wheel bearing slightly noisy (5.1.3 (b) (i))

Oil leak, but not excessive front crank pulley seal (8.4.1 (a) (i))

Oil leak, but not excessive crank pulley seal (8.4.1 (a) (i))

Nearside Front Inner Anti-roll bar pin or bush excessively worn (5.3.4 (a) (i))

Oil leak, but not excessive crank pulley seal (8.4.1 (a) (i))

Supplementary restraint system warning lamp indicates a fault (7.1.6 (a))

Nearside Front coil spring broken (2.4.C.1a)

Nearside Rear Registration plate lamp not working (1.1.C.1d)

Supplementary Restraint System warning lamp indicates a fault (5.4.2)

Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Front brake disc in such a condition that it is seriously weakened (3.5.1i)

Rear Brake pad(s) less than 1.5 mm thick (3.5.1g)

Nearside Headlamp aim too high (1.8)

Offside Headlamp aim too high (1.8)