2007 Mazda 6

Nearside Front Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Nearside Rear Service brake excessively binding (1.2.1 (f))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner sill (5.3.6 (a) (i))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength outer sill (5.3.6 (a) (i))

Offside Front Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Offside Front Seat belt anchorage prescribed area strength or continuity significantly reduced floor (7.1.1 (a) (i))

Front Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (1.2.1 (b) (i))

Front Headlamp has a product on the lens but not seriously reducing light output both (4.1.4 (b))

Nearside Front Service brake binding but not excessively (1.2.1 (f))

Nearside Front Service brake fluctuating, but not excessively (1.2.1 (e))

Nearside Rear Lower Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))

Nearside Rear Suspension arm pin or bush worn but not resulting in excessive movement trailing arm front bush (5.3.4 (a) (i))

Offside Front Corrosion next to engine mount

Offside Front Wheel bearing has slight play (5.1.3 (a) (i))

Offside Rear Lower Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))

Offside Rear Suspension arm pin or bush worn but not resulting in excessive movement trailing arm front bush (5.3.4 (a) (i))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

general underbody corrosion throughout underside of vehicle

Offside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

surface corrosion throughout underside of vehicle

Nearside Front Anti-roll bar linkage ball joint has slight play (5.3.4 (a) (i))

Nearside Rear Shock absorbers has light misting of oil (5.3.2 (b))

Offside Front Suspension component mounting prescribed area is corroded but not considered excessive inner wing, under bonnet (5.3.6 (a) (i))

corrosion to all rear suspension

Nearside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength floor (5.3.6 (a) (i))

Nearside Rear Seat belt anchorage prescribed area strength or continuity significantly reduced sill (7.1.1 (a) (i))

Offside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength floor (5.3.6 (a) (i))

Offside Rear Seat belt anchorage prescribed area strength or continuity significantly reduced sill (7.1.1 (a) (i))

Offside Seat belt anchorage prescribed area strength or continuity significantly reduced outer sill (7.1.1 (a) (i))

Nearside Rear Shock absorbers has light misting of oil (5.3.2 (b))

Offside Front Suspension component mounting prescribed area is corroded but not considered excessive inner wing (5.3.6 (a) (i))

Offside Seat belt anchorage prescribed area is corroded but not considered excessive outer sill (7.1.1 (a) (i))

slight corrosion on both floor to sills

Offside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

corrosion throughout underside of vehicle

slight corrosion throughout underside of vehicle

Nearside Rear Coil spring fractured or broken (5.3.1 (b) (i))

Offside Front Lower Suspension arm ball joint excessively worn (5.3.4 (a) (i))

slight corrosion throughout underside of vehicle

Front Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Nearside Rear Lower Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))

Nearside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Rear Lower Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))

Offside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Rear Integral body structure is corroded but structural rigidity is not significantly reduced rear floors and inner sills both sides (6.1.1 (c) (i))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Rear Suspension component pin or bush slightly worn both rear trailing arm bushes (5.3.4 (a) (i))

steering rack noisy

Front Brakes imbalanced across an axle 39% (1.2.1 (b) (i))

Nearside Front Outer Suspension arm ball joint dust cover no longer prevents the ingress of dirt front arm (5.3.4 (b) (ii))

Offside Front Outer Suspension arm ball joint dust cover no longer prevents the ingress of dirt front arm (5.3.4 (b) (ii))

Front Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii)) DANGEROUS

Front Brake disc worn, pitted or scored, but not seriously weakened both sides inner faces worn (1.1.14 (a) (ii))

Front Service brake fluctuating, but not excessively (1.2.1 (e))

Front Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Nearside Headlamp aim too high (4.1.2 (a))

Nearside Rear Lower Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))

Nearside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Headlamp aim too high (4.1.2 (a))

Offside Rear Lower Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))

Offside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Rear Integral body structure is corroded but structural rigidity is not significantly reduced rear floors and inner sills both sides (6.1.1 (c) (i))

Rear Service brake fluctuating, but not excessively (1.2.1 (e))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Rear Suspension component pin or bush slightly worn both rear trailing arm bushes (5.3.4 (a) (i))

steering rack noisy

Rear Brake pad(s) wearing thin (3.5.1g)

Nearside Rear Anti-roll bar linkage ball joint dust cover deteriorated, but preventing the ingress of dirt (2.4.G.2)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Rear Anti-roll bar linkage ball joint dust cover deteriorated, but preventing the ingress of dirt (2.4.G.2)

Nearside Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Nearside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Offside Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Offside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)