2007 Mazda 6

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Exhaust carbon monoxide content after 2nd fast idle exceeds default limits (8.2.1.2 (b))

Exhaust carbon monoxide content at idle exceeds default limits (8.2.1.2 (b))

Both headlight patterns are starting to diffuse

Front Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Nearside Rear Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Nearside rear handbrake effoet is 50% of offside advise investigation

Offside Front Lower Suspension arm ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Offside Rear Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Vehicle floorpan is corroded

Exhaust has a minor leak of exhaust gases Flex pipe (6.1.2 (a))

Nearside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Exhaust has a minor leak of exhaust gases Flex pipe (6.1.2 (a))

Nearside Front Headlamp aim too high (4.1.2 (a))

Nearside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Rear Exhaust emissions likely to be affected by an exhaust leak box (8.2.2.1 (b))

Vehicle structure is corroded but structural rigidity is not significantly reduced under the floor few places (6.1.1 (c) (i))

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Exhaust carbon monoxide content after 2nd fast idle exceeds manufacturer's specified limits (8.2.1.2 (a))

Exhaust hydrocarbon content after 2nd fast idle exceeds manufacturer's specified limits (8.2.1.2 (a))

Nearside Suspension arm ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Rear Tyre worn close to the legal limit both (4.1.E.1)

Nearside Front Brake pipe excessively corroded to flexi (3.6.B.2c)

Offside Rear Anti-roll bar ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt (2.4.G.2)

Rear Tyre worn close to the legal limit both (4.1.E.1)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Nearside Front Suspension arm ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt rear (2.4.G.2)

Nearside Rear Anti-roll bar linkage ball joint dust cover excessively damaged so that it no longer prevents the ingress of dirt (2.4.G.2)

Offside Front Suspension arm ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt front (2.4.G.2)

Offside Front Suspension arm ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt rear (2.4.G.2)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Front Windscreen wiper does not clear the windscreen effectively (8.2.2)

Front brake disc in such a condition that it is seriously weakened (3.5.1i)

Rear Brake pad(s) wearing thin (3.5.1g)

Front Windscreen wiper does not clear the windscreen effectively (8.2.2)

Offside Headlamp aim too high (1.8)

Front Brake pad(s) wearing thin (3.5.1g)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Front Brake pad(s) wearing thin (3.5.1g)

Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Parking brake lever has no reserve travel (3.1.6b)

Nail in offside rear tyre

Rear Brake pad(s) wearing thin (3.5.1g)

Child seat fitted not allowing full inspection of adult belt

Front Brake pad(s) wearing thin (3.5.1g)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Rear Brake pad(s) wearing thin (3.5.1g)