2002 Subaru Forester

Nearside Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Front Inner Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Offside Front Service brake binding but not excessively (1.2.1 (f))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Nearside Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside Front Windscreen washer provides insufficient washer liquid (3.5 (a))

Offside Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Front Inner Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Offside Front Registration plate lamp does not illuminate simultaneously with the position lamps (4.7.2 (a))

Offside Front Service brake binding but not excessively (1.2.1 (f))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Offside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Front Brake pad(s) wearing thin (3.5.1g)

Nearside Rear Brake pipe slightly corroded pipe ends (3.6.B.2c)

Nearside Rear Radius arm has slight play in a pin/bush front bush (2.4.G.2)

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Offside Rear Brake pipe slightly corroded pipe ends (3.6.B.2c)

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Fuel cap/sealing device does not fasten securely maintaining the sealing arrangement (7.2.4b)

Nearside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a) DANGEROUS

Front Brake pad(s) wearing thin (3.5.1g)

Nearside Rear Brake pipe slightly corroded pipe ends (3.6.B.2c)

Nearside Rear Radius arm has slight play in a pin/bush front bush (2.4.G.2)

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Offside Front tyre wall cracking

Offside Rear Brake pipe slightly corroded pipe ends (3.6.B.2c)

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Offside Rear tyre wall cracking

both rear wheel arches repaired

Nearside Inner Front constant velocity joint gaiter damaged to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)

Nearside Rear Suspension spring mounting prescribed area is excessively corroded (2.4.A.3)

Offside Rear Brake pipe excessively corroded (3.6.B.2c)

Offside Rear Suspension spring mounting prescribed area is excessively corroded (2.4.A.3)

Front Exhaust has a major leak of exhaust gases (7.1.2)

Child seat fitted not allowing full inspection of adult belt

exhaust rear coroded

Nearside Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Nearside Rear Brake pipe excessively corroded (3.6.B.2c)

Nearside Front position lamp(s) not working (1.1.A.3b)

Nearside Front position lamp(s) not working (1.1.A.3b)

Nearside Rear position lamp(s) excessively deteriorated so that it is not visible from a reasonable distance (1.1.A.3d)

Nearside Registration plate lamp not working (1.1.5c)

Nearside Windscreen wiper blade insecure (8.2.2)

Offside Headlamp aim too low (1.8)