2005 Toyota Aygo

Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (1.2.1 (b) (i))

Nearside Front Track rod end ball joint has slight play (2.1.3 (b) (i))

Offside Front Anti-roll bar pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Rear Brake pipe corroded, covered in grease or other material rear (1.1.11 (c))

Rear Coil spring corroded both side (5.3.1 (b) (i))

Rear Shock absorbers has slight external damage to the casing both side (5.3.2 (b))

hand brake lever slightly high

under body slightly corrosion

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Exhaust has a major leak of exhaust gases (6.1.2 (a))

Front Vehicle structure is fractured and structural rigidity is significantly reduced (6.1.1 (a) (i))

Nearside Rear Seat belt anchorage prescribed area strength or continuity significantly reduced (7.1.1 (a) (i))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Offside Rear Seat belt anchorage prescribed area strength or continuity significantly reduced (7.1.1 (a) (i))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Nearside Front Inner Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Front Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Front Subframe mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Nearside Front Inner Track rod end ball joint has slight play (2.1.3 (b) (i))

Nearside Rear Tyre has a cut but not deep enough to reach the ply or cords (5.2.3 (d) (i))

Offside Front Anti-roll bar pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Front Nail in tyre ()

Offside Tyre has a cut but not deep enough to reach the ply or cords (5.2.3 (d) (i))

Rear Brake drum worn, pitted or scored, but not seriously weakened both sides (1.1.14 (a) (ii))

Rear Coil spring corroded both sides (5.3.1 (b) (i))

Rear Suspension component mounting prescribed area is corroded but not considered excessive both (5.3.6 (a) (i))

Shock absorbers has slight external damage to the casing both sides (5.3.2 (b))

front cross member corroded

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Exhaust has a major leak of exhaust gases (6.1.2 (a))

Front Vehicle structure is fractured and structural rigidity is significantly reduced (6.1.1 (a) (i))

Nearside Rear Seat belt anchorage prescribed area strength or continuity significantly reduced (7.1.1 (a) (i))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Offside Rear Seat belt anchorage prescribed area strength or continuity significantly reduced (7.1.1 (a) (i))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Nearside Front Inner Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Front Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Front Subframe mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Nearside Front Inner Track rod end ball joint has slight play (2.1.3 (b) (i))

Nearside Rear Tyre has a cut but not deep enough to reach the ply or cords (5.2.3 (d) (i))

Offside Front Anti-roll bar pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Front Nail in tyre ()

Offside Tyre has a cut but not deep enough to reach the ply or cords (5.2.3 (d) (i))

Rear Brake drum worn, pitted or scored, but not seriously weakened both sides (1.1.14 (a) (ii))

Rear Coil spring corroded both sides (5.3.1 (b) (i))

Rear Suspension component mounting prescribed area is corroded but not considered excessive both (5.3.6 (a) (i))

Shock absorbers has slight external damage to the casing both sides (5.3.2 (b))

front cross member corroded

Brake lever has insufficient reserve travel (1.1.2 (a))

Hazard warning switch inoperative (4.4.2 (a) (ii))

Nearside Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (5.2.3 (d) (i))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Nearside Seat belt anchorage prescribed area strength or continuity significantly reduced under sill (7.1.1 (a) (i))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Offside Seat belt anchorage prescribed area strength or continuity significantly reduced under sill (7.1.1 (a) (i))

Rear Exhaust emissions likely to be affected by an exhaust leak (8.2.2.1 (b))

Front Subframe mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Nearside Rear Tyre has a cut but not deep enough to reach the ply or cords (5.2.3 (d) (i))

Offside Tyre has a cut but not deep enough to reach the ply or cords (5.2.3 (d) (i))

Front Sub-frame corroded but not seriously weakened (2.4.G.1)

Nearside Front Macpherson strut corroded but not seriously weakened (2.4.G.1)

Offside Front Macpherson strut corroded but not seriously weakened (2.4.G.1)

Central Exhaust has a major leak of exhaust gases (7.1.2)

Exhaust emissions Lambda reading after 2nd fast idle outside specified limits (7.3.D.3)

Nearside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Nearside Seat belt anchorage prescribed area is excessively corroded (5.2.6)

Offside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Seat belt anchorage prescribed area is excessively corroded (5.2.6)

Front Sub-frame corroded but not seriously weakened (2.4.G.1)

Nearside Front Macpherson strut corroded but not seriously weakened (2.4.G.1)

Offside Front Macpherson strut corroded but not seriously weakened (2.4.G.1)

front cross member getting corroded

metal part of all brake flexis getting corroded

underside getting corroded

Driver's airbag obviously defective (5.4.1)

Exhaust emissions Lambda reading after 2nd fast idle outside specified limits (7.3.D.3)

Exhaust has a major leak of exhaust gases (7.1.2)

front cross member getting corroded

metal part of all brake flexis getting corroded

underside getting corroded

Electronic power steering warning lamp indicates a failure in the system (2.3.8)

Front suspension locking device missing offside front ball joint castle nut (2.5.A.4)

Offside Front Tyre(s) incorrect because different size tyres are fitted on the same axle. (4.1.A.1a)

Offside Front position lamp(s) not working (1.1.A.3b)

Steering locking device missing offside track rod end castle nut (2.2.C.1g)

Offside Headlamp aim too low (1.8)

Nearside Front Anti-roll bar linkage rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Front Anti-roll bar linkage rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Nearside Rear Brake pipe excessively corroded (3.6.B.2c)

Nearside Registration plate lamp not working (1.1.C.1d)

Offside Front Front position lamp(s) obviously incorrectly positioned (1.1.A.3a)

Offside Rear Brake pipe excessively corroded (3.6.B.2c)

Offside Registration plate lamp not working (1.1.C.1d)

slight corrossion nearside front to rear brake pipe

slight corrossion offside front to rear brake pipe

wiper smearing slightly

Offside Headlamp aim too low (1.8)

slight corrossion nearside front to rear brake pipe

slight corrossion offside front to rear brake pipe

wiper smearing slightly