2005 Toyota Aygo

Front Subframe mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Nearside Front Brake pipe corroded, covered in grease or other material to rear (1.1.11 (c))

Nearside Rear Inner Suspension component mounting prescribed area is corroded but not considered excessive floor (5.3.6 (a) (i))

Nearside Front Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Nearside Front Suspension arm pin or bush excessively worn (5.3.4 (a) (i))

Nearside Rear Inner Suspension component mounting prescribed area excessively corroded significantly reducing structural strength floor (5.3.6 (a) (i))

Nearside Rear Inner Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill (5.3.6 (a) (i))

Nearside Rear Outer Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill (5.3.6 (a) (i))

Offside Front Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Offside Front Suspension arm pin or bush excessively worn (5.3.4 (a) (i))

Offside Rear Outer Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill (5.3.6 (a) (i))

Offside Rear Parking brake inoperative on one side (1.4.1 (a))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Front Subframe mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Nearside Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Front Brake pipe corroded, covered in grease or other material to rear (1.1.11 (c))

Nearside Rear Inner Suspension component mounting prescribed area is corroded but not considered excessive floor (5.3.6 (a) (i))

Nearside Rear Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Offside Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Rear Service brake binding but not excessively (1.2.1 (f))

slight corrosion to rear brake pipes

Nearside Front Brake pipe slightly corroded to rear (3.6.B.2c)

Nearside Headlamp has a product on the lens but not seriously reducing light output (1.7.5a)

Offside Front Brake pipe slightly corroded to rear (3.6.B.2c)

Offside Headlamp has a product on the lens but not seriously reducing light output (1.7.5a)

both headlamp reflectors tarnished but still displaying a pattern

Nearside Front Front suspension has slight movement at a wishbone pin or bush (2.5.A.1c)

both front tyres tread cracking and low 3mm

Nearside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Offside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Supplementary Restraint System warning lamp indicates a fault (5.4.2)

both front tyres tread cracking and low 3mm

Front front brake juddering slightly (3.7.A.2b)

air bag lamp on

n/s rear tyre tread cracking

o/s rear tyre tread cracking

air bag lamp on

o/s rear tyre tread cracking

Windscreen has a sticker or other obstruction encroaching by more than 10mm within zone 'A' (8.3.1b)

air bag lamp on

o/s rear tyre tread cracking

Nearside Headlamp aim too low (1.8)