2006 Toyota Aygo

Front Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Nearside Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Front Coil spring corroded (5.3.1 (b) (i))

Nearside Front Macpherson strut corroded but not seriously weakened (5.3.3 (b) (i))

Nearside Front Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Nearside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside Rear Coil spring corroded (5.3.1 (b) (i))

Nearside Rear Service brake binding but not excessively (1.2.1 (f))

Nearside Rear Suspension component mounting repair covered in underseal (5.3.6 (a) (i))

Nearside Rear Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Nearside Sill Damaged

Nearside Suspension component mounting prescribed area is corroded but not considered excessive Sill (5.3.6 (a) (i))

Offside Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Front Coil spring corroded (5.3.1 (b) (i))

Offside Front Macpherson strut corroded but not seriously weakened (5.3.3 (b) (i))

Offside Front Wheel bearing slightly noisy (5.1.3 (b) (i))

Offside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Rear Coil spring corroded (5.3.1 (b) (i))

Offside Rear Service brake binding but not excessively (1.2.1 (f))

Offside Rear Suspension component mounting repair covered in underseal (5.3.6 (a) (i))

Offside Suspension component mounting prescribed area is corroded but not considered excessive Sill (5.3.6 (a) (i))

Rear Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (1.2.1 (b) (i))

Rear Registration plate deteriorated but not likely to be misread (0.1 (b))

ns outer sill damaged

Hazard warning switch inoperative (4.4.2 (a) (ii))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength chassis (5.3.6 (a) (i))

Offside Front Service brake excessively binding (1.2.1 (f))

Offside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner sill (5.3.6 (a) (i))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength chassis (5.3.6 (a) (i))

ns outer sill damaged

ns outer sill damaged

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Nearside Front Headlamp not working on dipped beam (4.1.1 (a) (ii))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength chassis near rear crossmember fixing (5.3.6 (a) (i))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength outer sill (5.3.6 (a) (i))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength chassis rear cross member fixing (5.3.6 (a) (i))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength outer sill (5.3.6 (a) (i))

Brake pipe corroded, covered in grease or other material front / rear (1.1.11 (c))

Nearside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Front Suspension arm ball joint has slight play (5.3.4 (a) (i))

Offside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Headlamp aim too high and too far to the left. (1.8)

Offside Headlamp aim beam image obviously incorrect (1.8.A.1b)

Exhaust emissions carbon monoxide content after 2nd fast idle excessive (7.3.D.3)

Exhaust emissions carbon monoxide content at idle excessive (7.3.D.4)

Nearside Headlamp aim too low and too far to the right. (1.8)

Nearside Registration plate lamp not working (1.1.C.1d)

Offside Front suspension has excessive movement at a wishbone pin or bush (2.5.A.1c)

Offside Headlamp not working on dipped beam (1.7.5a)

Offside Registration plate lamp not working (1.1.C.1d)

Nearside Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a) DANGEROUS

o/s/f tyre feathered inner treead.

split in wiper blade.

Front brake disc in such a condition that it is seriously weakened (3.5.1i)

Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Nearside front brake binding (3.7.B.1)