2004 Ford Connect

Front Tyre worn close to legal limit/worn on edge both - slightly worn on inner edges (5.2.3 (e))

Front cross member/radiator support corroded

Rear Suspension component mounting prescribed area is corroded but not considered excessive both - outer sills (5.3.6 (a) (i))

Rear Suspension component mounting repair covered in underseal both - inner sills (5.3.6 (a) (i))

Spare tyre defective ()

Battery insecure and likely to fall from carrier (4.13 (a) (ii))

Nearside Inner Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Offside Seat belt anchorage prescribed area is inadequately repaired inner sill (7.1.1 (a) (i))

Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Seat belt anchorage prescribed area strength or continuity significantly reduced both - inner sills (7.1.1 (a) (i))

Service brake efficiency below requirements (1.2.2 (a) (i))

Suspension component mounting prescribed area excessively corroded significantly reducing structural strength both - inner sills (5.3.6 (a) (i))

Front Tyre worn close to legal limit/worn on edge both - slightly worn on inner edges (5.2.3 (e))

Front cross member/radiator support corroded

Offside Front Suspension arm ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Rear Suspension component mounting prescribed area is corroded but not considered excessive both - outer sills (5.3.6 (a) (i))

Rear Suspension component mounting repair covered in underseal both - inner sills (5.3.6 (a) (i))

Spare tyre defective ()

Brake pipe corroded, covered in grease or other material both front to rear pipes (1.1.11 (c))

Oil leak, but not excessive (8.4.1 (a) (i))

Nearside Front Outer Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt insecure (6.1.7 (g) (ii))

Nearside Front Track rod end ball joint has excessive play (2.1.3 (b) (i))

Nearside Inner Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting sill has holes all way down (6.2.2 (d) (i))

Nearside Rear Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting sill has hole at the rear (6.2.2 (d) (i))

Offside Front Wheel bearing rough when rotated (5.1.3 (b) (i))

Offside Inner Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting sill hyas holes all way down (6.2.2 (d) (i))

Offside Rear Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting sill has hole (6.2.2 (d) (i))

Brake pipe corroded, covered in grease or other material both front to rear pipes (1.1.11 (c))

Oil leak, but not excessive (8.4.1 (a) (i))

Nearside Front Anti-roll bar linkage ball joint dust cover excessively damaged so that it no longer prevents the ingress of dirt (2.4.G.2)

Nearside Front Brake pipe excessively corroded (3.6.B.2c)

Nearside Front Front constant velocity joint gaiter damaged to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)

Nearside Front Inner Front constant velocity joint gaiter damaged to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)

Nearside Front Wheel nut(s) missing (4.2.A.1e)

Nearside Inner Suspension component mounting prescribed area is excessively corroded sill (2.4.A.3)

Nearside Outer Suspension component mounting prescribed area is excessively corroded sill (2.4.A.3)

Offside Front Anti-roll bar linkage ball joint dust cover excessively damaged so that it no longer prevents the ingress of dirt (2.4.G.2)

Offside Outer Suspension component mounting prescribed area is excessively corroded sill (2.4.A.3)

Parking brake lever has little reserve travel (3.1.6b)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Brake load sensing valve linkage seized (3.6.E.3)

Nearside Front Brake pipe excessively corroded (3.6.B.2c)

Nearside Front suspension ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt (2.4.G.2)

Nearside Rear Brake pipe excessively corroded (3.6.B.2c)

Offside Rear Body has a projection caused by damage bumper end cap (6.1.C.1)

Offside Rear position lamp(s) incorrect colour damaged lens showing white light (1.1.A.3e)

Parking brake lever has no reserve travel (3.1.6b)

Windscreen wiper blade insecure both (8.2.2)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

unable to fully inspect brake pipes due to coating applied

Nearside Front Anti-roll bar linkage has excessive play in a ball joint (2.4.G.2)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Rear Stop lamp not working (1.2.1b)

Nearside Rear Suspension component mounting prescribed area is excessively corroded outer sill (2.4.A.3)

Offside Front Brake pipe excessively corroded (3.6.B.2c)

Offside Front Front position lamp(s) not working (1.1.A.3b)

Offside Front Suspension component mounting prescribed area is excessively corroded outer sill (2.4.A.3)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Rear Stop lamp not working (1.2.1b)

unable to fully inspect brake pipes due to coating applied

Nearside Front suspension ball joint dust cover deteriorated, but preventing the ingress of dirt (2.4.G.2)

Offside Headlamp not working on dipped beam (1.7.5a)

Offside Rear Suspension spring mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Rear Brake pipe slightly corroded (3.6.B.2c)

Registration plate lamp not working (1.1.C.1d)

n/s inner cvj boot split

Nearside Front suspension ball joint dust cover deteriorated, but preventing the ingress of dirt (2.4.G.2)

Offside Rear Suspension spring mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Rear Brake pipe slightly corroded (3.6.B.2c)

n/s inner cvj boot split

Brake pipe slightly corroded (3.6.B.2c)

Offside Front Brake pipe slightly corroded (3.6.B.2c)

centre exhaust slightly blowing

Centre Exhaust has a major leak of exhaust gases (7.1.2)

Horn not working (1.6.2a)

Nearside Front Anti-roll bar has excessive play in a ball joint (2.4.G.2)

Offside Rear Body has a sharp edge caused by damage (6.1.C.1)

Registration plate lamp not working (1.1.C.1d)

Nearside Front Anti-roll bar has slight play in a ball joint (2.4.G.2)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Rear Body has a sharp edge caused by damage (6.1.C.1)

Nearside Front Anti-roll bar has slight play in a ball joint (2.4.G.2)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Front Tyre worn close to the legal limit (4.1.E.1)