2006 Subaru Outback

Chassis has been undersealed

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Rear Coil spring corroded (5.3.1 (b) (i))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Oil leak, but not excessive (8.4.1 (a) (i))

Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Rear Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Rear Sub-frame is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Chassis has been undersealed

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Rear Coil spring corroded (5.3.1 (b) (i))

Offside Front Headlamp not working on dipped beam (4.1.1 (a) (ii))

Oil leak, but not excessive (8.4.1 (a) (i))

Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Rear Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Rear Sub-frame is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Offside Front Anti-roll bar linkage ball joint has slight play (5.3.4 (a) (i))

Suspension arm pin or bush worn but not resulting in excessive movement Both Front Wishbone Rear Bushes (5.3.4 (a) (i))

Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))

Exhaust system insecure All Mountings On Both Backboxes (6.1.2 (a))

Nearside Front Headlamp not working on dipped beam (4.1.1 (a) (ii))

Nearside Rear Vehicle structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting Inner Sill (6.2.2 (d) (i))

Offside Front Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced Floor Area (6.1.1 (c) (i))

Offside Rear Vehicle structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting (6.2.2 (d) (i))

Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Offside Front Anti-roll bar linkage ball joint has slight play (5.3.4 (a) (i))

Offside Front CV Joint Noisy

Suspension arm pin or bush worn but not resulting in excessive movement Both Front Wishbone Rear Bushes (5.3.4 (a) (i))

Nearside Front Suspension arm pin or bush worn but not resulting in excessive movement rear bush (5.3.4 (a) (i))

Nearside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside Rear Suspension arm pin or bush worn but not resulting in excessive movement trailing arm (5.3.4 (a) (i))

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Offside Front Suspension arm pin or bush worn but not resulting in excessive movement rear bush (5.3.4 (a) (i))

Offside Rear Suspension arm pin or bush worn but not resulting in excessive movement trailing arm (5.3.4 (a) (i))

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Nearside Front Inner Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Nearside Front Lower Suspension arm ball joint excessively worn (5.3.4 (a) (i))

Nearside Rear Brake disc significantly and obviously worn (1.1.14 (a) (i))

Nearside Front Suspension arm pin or bush worn but not resulting in excessive movement rear bush (5.3.4 (a) (i))

Nearside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside Rear Suspension arm pin or bush worn but not resulting in excessive movement trailing arm (5.3.4 (a) (i))

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Offside Front Inner Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Offside Front Suspension arm pin or bush worn but not resulting in excessive movement rear bush (5.3.4 (a) (i))

Offside Rear Suspension arm pin or bush worn but not resulting in excessive movement trailing arm (5.3.4 (a) (i))

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Nearside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Rear Brake disc worn, pitted or scored, but not seriously weakened both (1.1.14 (a) (ii))

Central Exhaust has a minor leak of exhaust gases (7.1.2)

Nearside Front suspension ball joint dust cover damaged, but preventing the ingress of dirt (2.4.G.2)

Offside Front wheel bearing has slight play (2.5.A.3c)

Exhaust emissions Lambda reading after 2nd fast idle outside specified limits (7.3.D.3)

Exhaust emissions carbon monoxide content after 2nd fast idle excessive (7.3.D.3)

Exhaust emissions carbon monoxide content at idle excessive (7.3.D.4)

Exhaust emissions hydrocarbon content after 2nd fast idle excessive (7.3.D.3)

Nearside Front suspension ball joint dust cover damaged, but preventing the ingress of dirt (2.4.G.2)

Offside Front wheel bearing has slight play (2.5.A.3c)

Front Suspension arm rubber bush deteriorated but not resulting in excessive movement rear bush both sides (2.4.G.2)

Rear Anti-roll bar linkage has slight play in a ball joint both sides (2.4.G.2)

Nearside Front brake disc in such a condition that it is seriously weakened (3.5.1i)

Offside Front brake disc in such a condition that it is seriously weakened (3.5.1i)

Offside Inner Front constant velocity joint gaiter damaged to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)

Nearside Rear Anti-roll bar has excessive play in a ball joint (2.4.G.2)

Rear Anti-roll bar has slight play in a ball joint (2.4.G.2)

Rear Tyre worn close to the legal limit (4.1.E.1)

NSF TYRE EDGE WEAR