2004 Subaru Forester

Anti-lock braking system warning lamp indicates an ABS fault (1.6 (b))

Nearside Rear Brake hose ferrule excessively corroded (1.1.12 (f) (i))

Nearside Rear Inner Suspension component mounting prescribed area excessively corroded significantly reducing structural strength Strut tower (5.3.6 (a) (i))

Offside Front Position lamp not working (4.2.1 (a) (ii))

Offside Rear Inner Suspension component mounting prescribed area excessively corroded significantly reducing structural strength Strut tower (5.3.6 (a) (i))

Offside Rear Brake hose ferrule excessively corroded and likely to fail (1.1.12 (f) (ii)) DANGEROUS

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Windscreen wiper blade defective (3.4 (b) (i))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Rear Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Nearside Rear Brake hose has slight corrosion to ferrule (1.1.12 (f) (i))

Offside Rear Brake hose has slight corrosion to ferrule (1.1.12 (f) (i))

Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))

Nearside Rear Upper Suspension component mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Rear Anti-roll bar fractured (5.3.3 (b) (ii)) DANGEROUS

Brake fluid close to minimum mark (1.1.10 (d) (ii))

Nearside Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Nearside Front Inner Brake pad(s) wearing thin (1.1.13 (a) (ii))

Offside Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Nearside Headlamp aim too low (1.8)

Nearside Registration plate lamp not working (1.1.C.1d)

Offside Headlamp aim too high (1.8)

Offside Rear Inner Brake pipe excessively corroded (3.6.B.2c)

Offside Rear Outer Brake pipe excessively corroded (3.6.B.2c)

Exhaust emissions Lambda reading after 2nd fast idle outside specified limits (7.3.D.3)

Exhaust emissions carbon monoxide content after 2nd fast idle excessive (7.3.D.3)

Nearside Headlamp cleaning device obviously defective (1.7.2)

Nearside Brake pad(s) less than 1.5 mm thick (3.5.1g)

Offside Front Brake pad(s) less than 1.5 mm thick (3.5.1g)