2007 Honda Accord

Nearside Rear Anti-roll bar linkage ball joint has slight play (5.3.4 (a) (i))

Offside Front Anti-roll bar linkage ball joint has slight play (5.3.4 (a) (i))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Rear Anti-roll bar linkage pin or bush worn but not resulting in excessive movement Both sides (5.3.4 (a) (i))

Rear Registration plate deteriorated but not likely to be misread (0.1 (b))

Nearside Rear Anti-roll bar linkage ball joint has slight play (5.3.4 (a) (i))

Offside Rear Anti-roll bar linkage ball joint has slight play (5.3.4 (a) (i))

Offside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Rear Registration plate deteriorated but not likely to be misread (0.1 (b))

Nearside Rear Anti-roll bar linkage ball joint has slight play (5.3.4 (a) (i))

general underside of vehicle has light corrosion/surface rust

o/s/r wheel arch slightly corroded

Nearside Rear floor to sill flange area/chassis along its length is corroding.

Offside Front floor to sill flange along its length is corroding.

Offside Rear floor to sill flange area/chassis along its length is corroding.

The front fog lamps do not illuminate when required

Nearside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Windscreen damaged but not adversely affecting driver's view (3.2 (a) (i))

Offside Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

Power steering fluid level below minimum (2.3.1)

Power steering pipe(s) or hose(s) leaking (2.3.3b)

Offside Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

2 x engine warning lights showing on dash display

Nearside Front Brake pad(s) wearing thin (3.5.1g)

Offside Front Brake pad(s) wearing thin (3.5.1g)

Offside Outer Rear position lamp(s) not working (1.1.A.3b)

Offside Rear Brake pad(s) wearing thin (3.5.1g)

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

Nearside Rear Stop lamp not working (1.2.1b)

Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)