2010 Honda Civic

Rear Brake pipe corroded, covered in grease or other material both sides (1.1.11 (c))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Rear vehicle underbody has slight surface corrosion

Offside Front Road wheel fixing missing (5.2.1 (a) (i))

Offside Rear Road wheel fixing missing (5.2.1 (a) (i))

Rear Brake pipe corroded, covered in grease or other material both sides (1.1.11 (c))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Rear vehicle underbody has slight surface corrosion

Front Track rod end ball joint dust cover damaged or deteriorated, but preventing the ingress of dirt (2.1.3 (g) (i))

Offside Front Track rod end ball joint dust cover damaged or deteriorated, but preventing the ingress of dirt (2.1.3 (g) (i))

Offside Rear Road wheel fixing missing (5.2.1 (a) (i))

Offside Rear Stop lamp(s) not working (4.3.1 (a) (ii))

Parking brake efficiency less than 50% of the required value (1.4.2 (a) (ii)) DANGEROUS

Rear Brake disc in such a condition that it is seriously weakened (1.1.14 (a) (ii)) DANGEROUS

Front Brake disc worn, but not excessively (1.1.14 (a) (i))

Front Track rod end ball joint dust cover damaged or deteriorated, but preventing the ingress of dirt (2.1.3 (g) (i))

Offside Front Track rod end ball joint dust cover damaged or deteriorated, but preventing the ingress of dirt (2.1.3 (g) (i))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

General corrosion

Nearside Front Headlamp lens slightly defective (4.1.1 (b) (i))

Offside Rear Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Nearside Headlamp lens slightly defective (4.1.1 (b) (i))

Suspension arm pin or bush worn but not resulting in excessive movement in various places (5.3.4 (a) (i))

front and rear all mechanical components corroded

front and rear floor pan/sills corroded

tpms lamp on display

Anti-lock braking system warning lamp indicates an ABS fault (1.6 (b))

Nearside Rear Stop lamp(s) not working (4.3.1 (a) (ii))

Nearside Side repeater not working (4.4.1 (a) (ii))

Offside Front Position lamp not working (4.2.1 (a) (ii))

Offside Headlamp not working on dipped beam (4.1.1 (a) (ii))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Service brake efficiency below requirements (1.2.2 (a) (i))

Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Nearside Headlamp lens slightly defective (4.1.1 (b) (i))

Suspension arm pin or bush worn but not resulting in excessive movement in various places (5.3.4 (a) (i))

front and rear all mechanical components corroded

front and rear floor pan/sills corroded

tpms lamp on display

Front Brake disc worn, but not excessively (1.1.14 (a) (i))

Anti-roll bar linkage ball joint has slight play both front (5.3.4 (a) (i))

under trays fitted

Rear Brakes imbalanced across an axle Axle 2 (1.2.1 (b) (i))

Rear Brake disc in such a condition that it is seriously weakened (1.1.14 (a) (ii)) DANGEROUS

Rear Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii)) DANGEROUS

Anti-roll bar linkage ball joint has slight play both front (5.3.4 (a) (i))

Offside Front Service brake binding but not excessively (1.2.1 (f))

under trays fitted

Nearside Front Wheel bearing has slight play (5.1.3 (a) (i))

Rear Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

undertrays fitted

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Exhaust emissions likely to be affected by an exhaust leak (8.2.2.1 (b))

Nearside Front Anti-roll bar linkage ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Offside Front Anti-roll bar linkage ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Nearside Front Wheel bearing has slight play (5.1.3 (a) (i))

Rear Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

undertrays fitted

under trays fitted

Nearside Front Headlamp aim so that beam "kick up" is not visible on the screen (4.1.2 (a))

Offside Rear Stop lamp(s) not working (4.3.1 (a) (ii))

Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

under trays fitted

Offside Front Anti-roll bar linkage ball joint dust cover deteriorated, but preventing the ingress of dirt top (2.4.G.2)

under trays fitted

Nearside Front Headlamp aim beam image obviously incorrect (1.8.A.1b)

Nearside Rear Brake pad(s) less than 1.5 mm thick (3.5.1g)

Offside Rear Stop lamp not working (1.2.1b)

Rear Brakes imbalanced across an axle (3.7.B.5b)

Offside Front Anti-roll bar linkage ball joint dust cover deteriorated, but preventing the ingress of dirt top (2.4.G.2)

brake disc worn, pitted or scored, but not seriously weakened been over heated (3.5.1i)

n/s/rear brake binding slightly at time of test

under trays fitted

plastics fitted

Front Brake pad(s) wearing thin (3.5.1g)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Rear Brake pad(s) less than 1.5 mm thick (3.5.1g)

Front Brake pad(s) wearing thin (3.5.1g)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Nearside Front Headlamp aim too high (1.8)

Nearside Front Headlamp insecure (1.7.3)