2010 Audi A4

Central Exhaust system insecure sleeve (6.1.2 (a))

Front Headlamp aim too low both sides (4.1.2 (a))

Nearside Front Outer Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Nearside Front Upper Suspension arm pin or bush excessively worn (5.3.4 (a) (i))

Offside Front Upper Suspension arm pin or bush excessively worn (5.3.4 (a) (i))

Offside Windscreen washer jets misaligned and not providing sufficient fluid to the windscreen (3.5 (a))

Front Lower Shock absorbers has a slightly worn bush both sides (5.3.2 (c))

Nearside Front Brake hose slightly damaged (1.1.12 (b) (i))

Nearside Rear Outer Tyre slightly damaged (5.2.3 (d) (ii))

Rear Coil spring corroded both sides (5.3.1 (b) (i))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Rear Suspension component mounting prescribed area is corroded but not considered excessive both sides (5.3.6 (a) (i))

Central Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Central Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Rear Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Offside Front Coil spring fractured or broken (5.3.1 (b) (i))

Nearside Rear Tyre tread depth below requirements of 1.6mm inner edge very dangers to drive (5.2.3 (e)) DANGEROUS

Headlamp aim too low (4.1.2 (a))

Nearside Rear Headlamp levelling device inoperative (4.1.5 (a))

Offside Rear Shock absorbers has a serious fluid leak (5.3.2 (b))

Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

emission to clean to test

Nearside Front Tyre worn close to the legal limit 3mm (4.1.E.1)

Nearside Rear Shock absorber has a serious fluid leak (2.7.3)

Offside Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords 245/40/18 (4.1.D.1a)

Nearside Front Tyre worn close to the legal limit 3mm (4.1.E.1)

Under-trays fitted obscuring some underside components