1972 Morris Mini Clubman

Battery insecure but not likely to fall from carrier (4.13 (a) (i))

Electrical wiring insecure Battery terminals / wiring (4.11 (a) (i))

Nearside Front Outer Drive shaft joint constant velocity boot severely deteriorated Twisted (6.1.7 (g) (i))

Suspension component mounting repair covered in underseal Under side of vehicle covered in underseal (5.3.6 (a) (i))

Battery insecure (1.9.1)

Nearside Rear Subframe mounting prescribed area is inadequately repaired (2.4.A.3)

Nearside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Offside Rear Subframe mounting prescribed area is inadequately repaired (2.4.A.3)

Offside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Exhaust has a major leak of exhaust gases rear silencer (7.1.2)

Front registration plate not fixed vertically, or as close to vertical as is reasonably practical (6.3.2c)

Nearside Front wheel bearing rough when rotated (2.5.A.2)

Nearside Rear Subframe mounting prescribed area is excessively corroded at front (2.4.A.3)

Nearside Rear Subframe mounting prescribed area is inadequately repaired at rear (2.4.A.3)

Offside Front Lower Seat belt anchorage prescribed area is inadequately repaired (5.2.6)

Offside Front constant velocity joint gaiter insecure to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)

Offside Front wheel bearing has excessive play (2.5.A.3c)

Offside Rear Subframe mounting prescribed area is inadequately repaired at rear (2.4.A.3)

Nearside Front Seat belt insecurely fixed to the vehicles structure (5.2.1a) DANGEROUS

Nearside Front wheel bearing has excessive play (2.5.A.3c) DANGEROUS

Offside Rear Sub-frame attachment bracket/mounting corroded and its strength is seriously reduced (2.4.G.1) DANGEROUS

Offside Rear wheel bearing has slight play (2.6.2)

front subframe has been welded to the floor, not ideal.

Brake pedal creeps down while the pedal is held under pressure (3.3.B.1a)

Nearside Headlamp not working on dipped beam (1.7.5a)

Nearside Headlamp not working on main beam (1.7.5a)

Nearside Stop lamp not working (1.2.1b)

Offside Headlamp not working on dipped beam (1.7.5a)

Offside Headlamp not working on main beam (1.7.5a)

Offside Stop lamp not working (1.2.1b)

Brake pedal functionally incomplete (3.3.A.1a)

Nearside Headlamp aim too low (1.8)

Nearside Inner Front constant velocity joint gaiter insecure to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)

Nearside Rear wheel bearing rough when rotated (2.6.1)

Nearside Windscreen wiper not operating over a large enough area to give an adequate view (8.2.1c)

Nearside front brake binding (3.7.B.1)

Offside Headlamp aim too low (1.8)

Offside Inner Front constant velocity joint gaiter insecure to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)

Offside Outer Front constant velocity joint gaiter insecure to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)

Offside Windscreen wiper not operating over a large enough area to give an adequate view (8.2.1c)

Offside front brake binding (3.7.B.1)

Parking brake: efficiency below requirements (3.7.B.7)

Rear Brakes imbalanced across an axle Axle 2 (3.7.B.5b)

Registration plate lamp not working (1.1.C.1d)

Windscreen washer provides insufficient washer liquid (8.2.3)

Body has a sharp edge caused by damage (6.1.C.1)

Offside Front Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Front constant velocity joint gaiter insecurely mounted to its housing (2.5.C.1a)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

oil leak