2009 Peugeot 107

Front Sub-frame is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Nearside Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive Axle Mount (5.3.6 (a) (i))

Offside Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive Axle Mount (5.3.6 (a) (i))

Emissions unable to be completed exhaust blowing (8.2.1.2 (d))

Nearside Front Suspension arm ball joint excessively worn (5.3.4 (a) (i))

Offside Rear Stop lamp(s) not working (4.3.1 (a) (ii))

Front Sub-frame is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Nearside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Rear Axle Corroded

Rear Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Emissions unable to be completed (8.2.1.2 (d))

Exhaust emissions likely to be affected by an exhaust leak (8.2.1.1 (b))

Nearside Rear Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced Sill (6.1.1 (c) (i))

Offside Rear Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced Sill (6.1.1 (c) (i))

Supplementary restraint system warning lamp indicates a fault (7.1.6 (a))

Front Sub-frame is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Nearside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Rear Axle Corroded

Rear Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Nearside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside Rear Brake pipe excessively corroded (1.1.11 (c))

Offside Rear Brake pipe excessively corroded (1.1.11 (c))

Offside Rear Suspension component mounting prescribed area excessively damaged significantly reducing structural strength sill (5.3.6 (a) (i))

Offside Rear Suspension component mounting prescribed area excessively damaged significantly reducing structural strength sill (5.3.6 (a) (i))

Rear Brakes imbalanced across an axle (1.2.1 (b) (i))

Service brake efficiency below requirements (1.2.2 (a) (i))

Parking brake efficiency less than 50% of the required value (1.4.2 (a) (ii)) DANGEROUS

Brake pipe slightly corroded all underside (3.6.B.2c)

Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

exhauste in poor condition

Brake pipe slightly corroded as marked at rear (3.6.B.2c)

Brake pipe slightly corroded both front to rear (3.6.B.2c)

Nearside Front Brake pipe slightly corroded (3.6.B.2c)

Tyre worn close to the legal limit all (4.1.E.1)

Offside Front Brake pipe excessively corroded (3.6.B.2c)

Offside Rear rear brake binding (3.7.B.1)

Registration plate lamp not working both (1.1.C.1d)

Brake pipe slightly corroded both front to rear (3.6.B.2c)

Nearside Front Brake pipe slightly corroded (3.6.B.2c)

Tyre worn close to the legal limit all (4.1.E.1)

Nearside Front Anti-roll bar linkage rubber mounting deteriorated but not resulting in excessive movement (2.4.G.2)

Nearside Rear Brake pipe slightly corroded (3.6.B.2c)

Offside Front Anti-roll bar linkage rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Front Brake pipe slightly corroded (3.6.B.2c)

Offside Rear Brake pipe slightly corroded (3.6.B.2c)

lower arm rear bushes starting to split

Offside Front wheel bearing has slight play (2.5.A.3c)

Front front brake juddering severely (3.7.A.2b)

Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.5b)

Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)