2009 Jaguar X-type

Anti-lock braking system warning lamp indicates an ABS fault (1.6 (b))

Front Windscreen washer not working (3.5 (a))

Fuel tank insecure (6.1.3 (a) (i))

Nearside Front Anti-roll bar linkage ball joint excessively worn (5.3.4 (a) (i))

Nearside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength floor/inner sill area (5.3.6 (a) (i))

Nearside Front Track rod end ball joint has excessive play (2.1.3 (b) (i))

Nearside Rear Anti-roll bar pin or bush excessively worn (5.3.4 (a) (i))

Nearside Rear Lower Suspension arm pin or bush excessively worn (5.3.4 (a) (i))

Nearside Suspension component mounting prescribed area excessively corroded significantly reducing structural strength outer sill (5.3.6 (a) (i))

Offside Parking brake inoperative on one side (1.4.1 (a))

Offside Rear Anti-roll bar linkage insecurely attached fouling rear spring (5.3.3 (a) (i))

Offside Rear Anti-roll bar pin or bush excessively worn (5.3.4 (a) (i))

Offside Suspension component mounting prescribed area excessively corroded significantly reducing structural strength floor/inner sill area (5.3.6 (a) (i))

Offside Suspension component mounting prescribed area excessively corroded significantly reducing structural strength outer sill (5.3.6 (a) (i))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Brake pipe corroded, covered in grease or other material all original slight corrosion (1.1.11 (c))

Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Nearside Front Drive shaft joint constant velocity boot severely deteriorated slight weep (6.1.7 (g) (i))

Nearside Rear Brake pad(s) wearing thin uneven wear (1.1.13 (a) (ii))

central to rear exhaust clamp fractured

underside of vehicle showing corrosion

Offside Front Suspension component mounting prescribed area is corroded but not considered excessive sill (5.3.6 (a) (i))

Nearside Front Anti-roll bar linkage ball joint excessively worn (5.3.4 (a) (i))

Offside Front Anti-roll bar linkage insecurely attached (5.3.3 (a) (i))

Offside Front Suspension component mounting prescribed area is corroded but not considered excessive sill (5.3.6 (a) (i))

Front Registration plate does not conform to the specified requirements (0.1 (d))

Offside rear parking brake recording little or no effort (3.7.B.6a)

Parking brake: efficiency below requirements (3.7.B.7)

Parking brake: efficiency below requirements (3.7.B.7)