2013 Fiat Scudo

Offside Windscreen wiper blade defective (3.4 (b) (i))

Engine MIL inoperative or indicates a malfunction (8.2.2.2 (g))

Offside Windscreen wiper blade defective (3.4 (b) (i))

Offside Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Offside Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Offside Rear fog lamp not working (4.5.1 (a) (ii))

Front Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Front Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Offside Rear fog lamp not working (4.5.1 (a) (ii))

Offside Stop lamp(s) not working (4.3.1 (a) (ii))

3rd brake light inop

Nearside Front Lower Suspension arm ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Offside Front Lower slight movement in front lower roll bar link

abs light taken out time of test by scanner

front brakes 27% out of balance

o/s n/s front tyres on limit

slight movement in o/s front wheel bearing

Nearside Front Lower Suspension arm ball joint dust cover severely deteriorated (5.3.4 (b) (i))

evidence of power steering fluid around rack but no apparant leaks

n/s front tyre approaching ilimt

Direction indicator incorrect colour o/s n/s rear (4.4.3 (a))

Nearside Front Lower Suspension arm ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Parking brake inoperative on one side unseized time of test , n/s rear (1.4.1 (a))

evidence of power steering fluid around rack but no apparant leaks

n/s front tyre approaching ilimt

Exhaust has a major leak of exhaust gases (6.1.2 (a))

Nearside Front Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Offside Front Suspension arm ball joint excessively worn (5.3.4 (a) (i))

Exhaust system insecure (6.1.2 (a))

Offside Front Position lamp not working (4.2.1 (a))

Offside Rear Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Hazard warning switch faulty (4.4.2 (a) (i))

Offside Headlamp not working on dipped beam (1.7.5a)