2006 Toyota Aygo

Brake lever has insufficient reserve travel (1.1.2 (a))

Emissions unable to be completed (8.2.1.2 (d))

Front Service brake excessively fluctuating (1.2.1 (e))

Nearside Front Suspension arm pin or bush excessively worn (5.3.4 (a) (i))

Nearside Rear Vehicle structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting sill (6.2.2 (d) (i))

Offside Front Suspension arm pin or bush excessively worn (5.3.4 (a) (i))

Offside Rear Vehicle structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting sill (6.2.2 (d) (i))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Rear Exhaust has a major leak of exhaust gases (6.1.2 (a))

Brake pipe corroded, covered in grease or other material all pipes (1.1.11 (c))

Nearside Front Headlamp has a product on the lens but not seriously reducing light output (4.1.4 (b))

Nearside Rear Coil spring corroded (5.3.1 (b) (i))

Offside Front Headlamp has a product on the lens but not seriously reducing light output (4.1.4 (b))

Offside Front Service brake binding but not excessively (1.2.1 (f))

Offside Rear Coil spring corroded (5.3.1 (b) (i))

under body corrosion

Front Registration plate insecure but not likely to fall off (0.1 (a))

Front Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Rear Coil spring corroded both (5.3.1 (b) (i))

undersid ecorrosion

Brake pipe corroded, covered in grease or other material pipes from master cylinder to abs unit (1.1.11 (c))

Front Brake disc worn, pitted or scored, but not seriously weakened pads about 10% worn out (1.1.14 (a) (ii))

Nearside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside Front Lower Suspension arm pin or bush worn but not resulting in excessive movement rear bush (5.3.4 (a) (i))

Offside Front Lower Suspension arm pin or bush worn but not resulting in excessive movement rear bush (5.3.4 (a) (i))

Offside Rear Tyre worn close to legal limit/worn on edge 2.7mm tread 155/65 r14 75t (5.2.3 (e))

Brake lever has insufficient reserve travel (1.1.2 (a))

Brake pipe excessively corroded both front to rear (1.1.11 (c))

Nearside Front Position lamp not working (4.2.1 (a) (ii))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength from rear axle mounting (5.3.6 (a) (i))

Offside Front Anti-roll bar linkage pin or bush excessively worn (5.3.4 (a) (i))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Brake pipe corroded, covered in grease or other material pipes from master cylinder to abs unit (1.1.11 (c))

Front Brake disc worn, pitted or scored, but not seriously weakened pads about 10% worn out (1.1.14 (a) (ii))

Nearside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside Front Lower Suspension arm pin or bush worn but not resulting in excessive movement rear bush (5.3.4 (a) (i))

Nearside Rear Tyre obviously under inflated (5.2.3 (l))

Offside Front Lower Suspension arm pin or bush worn but not resulting in excessive movement rear bush (5.3.4 (a) (i))

Offside Rear Tyre worn close to legal limit/worn on edge 2.7mm tread 155/65 r14 75t (5.2.3 (e))

Nearside Front Shock absorbers has light misting of oil (5.3.2 (b))

Nearside Suspension component mounting repair covered in underseal (5.3.6 (a) (i))

Offside Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement bushes splitting (5.3.4 (a) (i))

Offside Front Shock absorbers has light misting of oil (5.3.2 (b))

Offside Suspension component mounting repair covered in underseal (5.3.6 (a) (i))

Oil leak, but not excessive transmission (8.4.1 (a) (i))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength hole 30cm within trailing arm mounting point (5.3.6 (a) (i))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength hole 30cm within trailing arm mounting point (5.3.6 (a) (i))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength outer sill (5.3.6 (a) (i))

Offside Rear Suspension arm pin or bush excessively worn bottom arm rear bush (5.3.4 (a) (i))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength hole 30cm within trailing arm mounting point (5.3.6 (a) (i))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength hole 30cm within trailing arm mounting point (5.3.6 (a) (i))

Suspension component mounting prescribed area excessively corroded significantly reducing structural strength hole 30cm within trailing arm mounting point (5.3.6 (a) (i))

Nearside Front Shock absorbers has light misting of oil (5.3.2 (b))

Offside Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement bushes splitting (5.3.4 (a) (i))

Offside Front Shock absorbers has light misting of oil (5.3.2 (b))

Offside Front Wheel bearing slightly noisy (5.1.3 (b) (i))

Oil leak, but not excessive transmission (8.4.1 (a) (i))

Nearside Front Suspension arm pin or bush excessively worn (5.3.4 (a) (i))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength chassis near rear axle mounting (5.3.6 (a) (i))

Nearside Suspension arm ball joint excessively worn (5.3.4 (a) (i))

Offside Front Lower Suspension arm pin or bush excessively worn rear bush (5.3.4 (a) (i))

Offside Parking brake inoperative on one side (1.4.1 (a))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Front Oil leak, but not excessive (8.4.1 (a) (i))

Offside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

front to rear brake pipes corroded

Nearside Front Suspension arm pin or bush excessively worn (5.3.4 (a) (i))

Offside Rear Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced (6.1.1 (c) (i))

Front Oil leak, but not excessive (8.4.1 (a) (i))

Offside Front Position lamp not working (4.2.1 (a))

Offside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

front to rear brake pipes corroded

Nail in tyre both o/s tyres ()

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Offside Rear Brake pipe excessively corroded (3.6.B.2c)

Brake pipe slightly corroded (3.6.B.2c)

Brake pipe slightly corroded (3.6.B.2c)

Nearside Rear Registration plate lamp not working (1.1.C.1d)

Rear registration plate delaminated (6.3.1d)

both front brake discs are scored and pitted on the inner faces

both front brake discs are scored and pitted on the inner faces