2008 Toyota Aygo

Front Brake disc worn, pitted or scored, but not seriously weakened both sides (1.1.14 (a) (ii))

Rear Brake pipe corroded, covered in grease or other material both sides to rubber hoses (1.1.11 (c))

Brake pedal has insufficient reserve travel brake pedal goes to the floor (1.1.2 (a))

Nearside Front Headlamp aim too low (4.1.2 (a))

Nearside Rear Service brake excessively binding (1.2.1 (f))

Offside Rear Hydraulic brake cylinder leaking hydraulic fluid wheel cylinder leaking (1.1.16 (b) (i))

Offside Rear Parking brake inoperative on one side (1.4.1 (a))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Rear Brakes imbalanced across an axle Axle 2 (1.2.1 (b) (i))

Rear Registration plate insecure (0.1 (a))

Service brake efficiency below requirements (1.2.2 (a) (i))

Offside Rear Service brake has no recorded effort at a wheel (1.2.1 (a) (ii)) DANGEROUS

Rear Brakes imbalanced across an axle by more than 50% (1.2.1 (b) (ii)) DANGEROUS

Front Brake disc worn, pitted or scored, but not seriously weakened both sides (1.1.14 (a) (ii))

Rear Brake pipe corroded, covered in grease or other material both sides to rubber hoses (1.1.11 (c))

Front Service brake excessively binding (1.2.1 (f))

Supplementary restraint system warning lamp indicates a fault (7.1.6 (a))

Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Nearside Rear Coil spring corroded (5.3.1 (b) (i))

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive sill panel (5.3.6 (a) (i))

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive wheel arch (5.3.6 (a) (i))

Front Windscreen washer provides insufficient washer liquid (3.5 (a))

Offside Rear Service brake excessively binding (1.2.1 (f))

Offside Rear Wheel bearing rough when rotated (5.1.3 (b) (i))

Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Nearside Indicator switch not able to be operated from the normal driving position switch contact made only when held on (4.4.2 (a) (i))

Nearside Rear Coil spring corroded (5.3.1 (b) (i))

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive sill panel (5.3.6 (a) (i))

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive wheel arch (5.3.6 (a) (i))

Nearside Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Rear Bumper insecure (6.1.4 (a) (i))

Nearside Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Offside Front position lamp(s) not working (1.1.A.3b)

Parking brake: efficiency below requirements (3.7.B.7)

both front tyres getting low

Offside Front Headlamp not working on dipped beam (1.7.5a)

Nearside Rear Seat belt retracting mechanism defective (5.2.5b) DANGEROUS

Nail in nearside rear tyre