2005 Toyota Aygo

Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement both side. (5.3.4 (a) (i))

Vehicle under body coating .

Front Brake disc worn, but not excessively inner . (1.1.14 (a) (i))

Rear Shock absorbers has a slightly worn bush both side . (5.3.2 (c))

Rear Suspension component mounting repair covered in underseal both side . (5.3.6 (a) (i))

Offside Rear Tyre has a bulge, caused by separation or partial failure of its structure 155/65/14 (5.2.3 (d) (ii)) DANGEROUS

Front Brake disc worn, but not excessively inner . (1.1.14 (a) (i))

Rear Shock absorbers has a slightly worn bush both side . (5.3.2 (c))

Rear Suspension component mounting repair covered in underseal both side . (5.3.6 (a) (i))

Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement both (5.3.4 (a) (i))

Headlamp lens slightly defective both sides (4.1.1 (b) (i))

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive outer sill (5.3.6 (a) (i))

Offside Front Outer Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Offside Obligatory mirror slightly damaged (3.3 (b) (i))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength outer sill (5.3.6 (a) (i))

Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement both (5.3.4 (a) (i))

Headlamp lens slightly defective both sides (4.1.1 (b) (i))

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive outer sill (5.3.6 (a) (i))

Offside Front Outer Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Offside Obligatory mirror slightly damaged (3.3 (b) (i))

Front Headlamp lens slightly defective offside and nearside (4.1.1 (b) (i))

Nearside Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Front Outer Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Offside Obligatory mirror slightly damaged (3.3 (b) (i))

Hazard warning lamps inoperative (4.4.1 (e))

Nearside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Nearside Rear Service brake excessively binding (1.2.1 (f))

Offside Front Anti-roll bar linkage pin or bush excessively worn (5.3.4 (a) (i))

Offside Rear Service brake excessively binding (1.2.1 (f))

Front Headlamp lens slightly defective offside and nearside (4.1.1 (b) (i))

Nearside Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Rear Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Anti-lock braking system warning lamp indicates an ABS fault (1.6 (b))

Nearside Front Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Offside Front Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Offside Rear Service brake excessively binding (1.2.1 (f))

Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Off side rear brake slightly binding

Offside Rear Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Offside Headlamp aim so that beam "kick up" is not visible on the screen (4.1.2 (a))

Offside Rear Tyre not fitted in accordance with side wall instructions (5.2.3 (i))

Offside rear brake binding slightly

Rear Shock absorber has a slightly worn bush Both (2.7.4)

Rear Shock absorber has slight corrosion to the casing Both (2.7.2a)

Rear Suspension component mounting prescribed area is corroded but not considered excessive Both (2.4.A.3)

Front Windscreen washer provides insufficient washer liquid Both (8.2.3)

Offside rear brake binding slightly

Rear Shock absorber has a slightly worn bush Both (2.7.4)

Rear Shock absorber has slight corrosion to the casing Both (2.7.2a)

Rear Suspension component mounting prescribed area is corroded but not considered excessive Both (2.4.A.3)

Hazard warning lamps not flashing in phase, with ignition off (1.4.B.1f)

Hazard warning lamps not flashing in phase, with ignition on (1.4.B.1f)

n/s/r tyre 2mm tread depth

o/s/r tyre 2mm tread depth

Hazard warning switch faulty (1.4.B.1d)

n/s/r tyre 2mm tread depth

o/s/r tyre 2mm tread depth

Front wiper loose on arm.

Nearside Headlamp aim too low (1.8)

Parking brake lever has no reserve travel (3.1.6b)