2007 Peugeot 107

Front Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Nearside Rear Subframe mounting repair covered in underseal (5.3.6 (a) (i))

Nearside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Offside Rear Subframe mounting repair covered in underseal (5.3.6 (a) (i))

loads of underseal under body

underseal/filler over repairs

Emissions unable to be completed (8.2.1.2 (d))

Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))

Nearside Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced outer sill (6.1.1 (c) (i))

Offside Front Suspension arm ball joint excessively worn (5.3.4 (a) (i))

Windscreen washer provides insufficient washer liquid (3.5 (a))

Front Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Nearside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

loads of underseal under body

Emissions unable to be completed (8.2.1.2 (d))

Nearside Rear Vehicle structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting chassie corroded (6.2.2 (d) (i))

Nearside Vehicle structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting inner sill (6.2.2 (d) (i))

Nearside Vehicle structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting outer sill (6.2.2 (d) (i))

Offside Rear Vehicle structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting chassie corroded (6.2.2 (d) (i))

Offside Vehicle structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting inner sill (6.2.2 (d) (i))

Offside Vehicle structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting outer sill (6.2.2 (d) (i))

Rear Exhaust emissions likely to be affected by an exhaust leak (8.2.1.1 (b))

Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Exhaust carbon monoxide content after 2nd fast idle exceeds manufacturer's specified limits (8.2.1.2 (a))

Exhaust carbon monoxide content after 2nd fast idle exceeds manufacturer's specified limits (8.2.1.2 (a))

Exhaust hydrocarbon content after 2nd fast idle exceeds default limits (8.2.1.2 (b))

Nearside Front Position lamp not working (4.2.1 (a) (ii))

Nearside Windscreen washer not working (3.5 (a))

Offside Rear Brake pipe excessively corroded (1.1.11 (c))

Offside Rear Service brake excessively binding (1.2.1 (f))

Nearside Rear Service brake excessively binding (1.2.1 (f))

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Nearside Headlamp aim too high (1.8)

Offside Front Suspension arm rubber bush bonding deteriorated resulting in excessive movement rear bush (2.4.G.2)

Offside Headlamp aim too low (1.8)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Exhaust has a minor leak of exhaust gases rear silensor (7.1.2)

exhaust mounting bracket broken

Nearside Front Suspension arm rubber mounting deteriorated but not resulting in excessive movement REAR MOUNTING (2.4.G.2)

Nearside Front Suspension arm rubber mounting deteriorated but not resulting in excessive movement REAR MOUNTING (2.4.G.2)

Offside Rear Registration plate lamp not working (1.1.C.1d)

Nearside Front Brake pipe slightly corroded (3.6.B.2c)

Offside Front Brake pipe slightly corroded (3.6.B.2c)

Exhaust emissions Lambda reading after 2nd fast idle outside specified limits (7.3.D.3)

Exhaust emissions carbon monoxide content after 2nd fast idle excessive (7.3.D.3)

Exhaust has a major leak of exhaust gases (7.1.2)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Rear Rear wheel bearing rough when rotated (2.6.1)

Offside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Nearside Front brake disc excessively pitted (3.5.1h)

Nearside front brake application uneven (3.7.B.2)

Offside Front brake disc excessively pitted (3.5.1h)

Offside front brake application uneven (3.7.B.2)