2007 Mercedes-benz C

Air/vacuum reservoir damaged and function impaired brake vac. assistance faulty (1.1.3 (e))

Central Rear Seat belt missing latch missing (7.1.2 (a))

Nearside Front Suspension arm ball joint excessively worn (5.3.4 (a) (i))

Offside Front Suspension arm ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Offside Front Track rod end ball joint has excessive play (2.1.3 (b) (i))

Offside Rear Parking brake inoperative on one side (1.4.1 (a))

Front Coil spring fractured or broken x2 (5.3.1 (b) (i))

Offside Front Track rod end ball joint has excessive play (2.1.3 (b) (i))

Rear Tyre worn close to the legal limit X2 (205/55X16) (4.1.E.1)

Front Brake pipe slightly corroded to flexis both sides (3.6.B.2c)

Nearside Front Front wheel bearing has slight play (2.5.A.3c)

Nearside Front slight play tie rod (drum stick)

Offside Front front brake fluctuating, but not excessively (3.7.B.3)

Front Brakes imbalanced across an axle n/s slow (3.7.B.5b)

Nearside Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Nearside Rear Anti-roll bar linkage rubber bush bonding deteriorated resulting in excessive movement (2.4.G.2)

Offside Front Front suspension has excessive play in a lower suspension ball joint front (2.5.B.1a)

Offside Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Offside Front Windscreen has damage to the swept area in excess of a 40mm circle outside zone 'A' (8.3.1d)

Offside Front front brake binding (3.7.B.1)

Offside Rear Anti-roll bar linkage rubber bush bonding deteriorated resulting in excessive movement (2.4.G.2)

Rear Exhaust has a major leak of exhaust gases tailbox blown (7.1.2)

rear parking (secondary) brakes imbalanced o/s slow (3.7.B.6b)

Front Brake pipe slightly corroded to flexis both sides (3.6.B.2c)

Nearside Front Front wheel bearing has slight play (2.5.A.3c)

Nearside Front slight play tie rod (drum stick)

Offside Front front brake fluctuating, but not excessively (3.7.B.3)

Offside Rear reverse light n/w

Rear Rear position lamp(s) slightly affected by the operation of another lamp BODY MODULE using back up system tail lights...ATTENTION required (1.1.A.3f)

park brake warning switch faulty...requires attention

Front Inner Brake pad(s) less than 1.5 mm thick warning lamp on (3.5.1g)

Nearside Front Inner Headlamp insecure reflector off mounting pins (1.7.3)

Nearside Headlamp aim too high (1.8)

Offside Front position lamp(s) not working (1.1.A.3b)

Offside Rear Brake pad(s) less than 1.5 mm thick uneven wear across axle (3.5.1g)

Offside Windscreen washer provides insufficient washer liquid blocked (8.2.3)

Parking brake: efficiency below requirements (3.7.B.7)

Offside Rear reverse light n/w

Nearside Front Brake pipe excessively corroded (3.6.B.2c)

Nearside Front Track rod end ball joint has excessive play (2.2.B.1f)

Nearside Registration plate lamp not working (1.1.C.1d)

Offside Front Brake pipe excessively corroded (3.6.B.2c)

Offside Front Suspension arm ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt (2.4.G.2)

Offside Headlamp not working on dipped beam (1.7.5a)

Nearside Front Brake pipe slightly corroded (3.6.B.2c)

Offside Front Brake pipe slightly corroded (3.6.B.2c)

Parking brake: parking brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.7)

n/s/r tyre wearing edges slightly

nail in o/s/r tyre

o/s/r tyre between 2-3mm

rear brake discs pitted

Offside rear brake excessively fluctuating (3.7.B.3)

Parking brake: parking brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.7)

n/s/r tyre wearing edges slightly

nail in o/s/r tyre

o/s/r tyre between 2-3mm

rear brake discs pitted

Under-trays fitted obscuring some underside components

handbrake warning light on

rear brake discs slightly pitted/scored

screw in n/s/r tyre

Offside Front Tyre worn close to the legal limit (4.1.E.1)