2003 Iveco Daily

Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside Front Vehicle structure is corroded but structural rigidity is not significantly reduced and o/s/f/inner arch also covered in underseal (6.1.1 (c) (i))

Nearside Rear Vehicle structure is corroded but structural rigidity is not significantly reduced and o/s/r inner arches (6.1.1 (c) (i))

all underside of body is covered in body seal unable to fully inspect

Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside Front Headlamp aim too low and o/s/f (4.1.2 (a))

Nearside Front Vehicle structure is corroded but structural rigidity is not significantly reduced and o/s/f/inner arch also covered in underseal (6.1.1 (c) (i))

Nearside Rear Vehicle structure is corroded but structural rigidity is not significantly reduced and o/s/r inner arches (6.1.1 (c) (i))

all underside of body is covered in body seal unable to fully inspect

Nearside Front Brake pipe excessively corroded (1.1.11 (c))

Nearside Front Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced (6.1.1 (c) (i))

Nearside Front Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced out rigger area (6.1.1 (c) (i))

Nearside Front Subframe mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Nearside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner wing/arch area (5.3.6 (a) (i))

Nearside Headlamp aim too low (4.1.2 (a))

Nearside Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced central out riggers and surrounding area (6.1.1 (c) (i))

Nearside Rear Anti-roll bar attachment bracket/mounting corroded and seriously weakened (5.3.3 (b) (i))

Nearside Rear Anti-roll bar linkage pin or bush excessively worn (5.3.4 (a) (i))

Nearside Rear Body mounting fixings insecure (6.2.2 (c) (i))

Nearside Rear Brake pipe excessively corroded (1.1.11 (c))

Nearside Rear Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced (6.1.1 (c) (i))

Nearside Rear Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced out rigger area (6.1.1 (c) (i))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner wing/arch area (5.3.6 (a) (i))

Nearside Seat belt anchorage prescribed area strength or continuity significantly reduced inner sill/floor area (7.1.1 (a) (i))

Offside Front Brake master cylinder/servo mounting prescribed area is excessively corroded bulk head area (1.1.21 (e) (i))

Offside Front Brake pipe excessively corroded (1.1.11 (c))

Offside Front Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced (6.1.1 (c) (i))

Offside Front Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced out rigger area (6.1.1 (c) (i))

Offside Front Subframe mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Offside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner wing arch area (5.3.6 (a) (i))

Offside Headlamp aim too low (4.1.2 (a))

Offside Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced central out riggers and surrounding area (6.1.1 (c) (i))

Offside Rear Anti-roll bar attachment bracket/mounting corroded and seriously weakened (5.3.3 (b) (i))

Offside Rear Anti-roll bar linkage pin or bush excessively worn (5.3.4 (a) (i))

Offside Rear Body mounting fixings insecure (6.2.2 (c) (i))

Offside Rear Brake pipe excessively corroded (1.1.11 (c))

Offside Rear Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced (6.1.1 (c) (i))

Offside Rear Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced out rigger area (6.1.1 (c) (i))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner wing/arch area (5.3.6 (a) (i))

Offside Seat belt anchorage prescribed area strength or continuity significantly reduced inner sill/floor area (7.1.1 (a) (i))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Rear Brakes imbalanced across an axle Axle 2 (1.2.1 (b) (i))

Rear Floor insecure (6.2.4 (a) (i))

Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Service brake efficiency below requirements (1.2.2 (a) (i))

Supplementary restraint system warning lamp indicates a fault (7.1.6 (a))

Nearside Front Brake pipe leaking on a hydraulic braking system (1.1.11 (b) (ii)) DANGEROUS

Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Battery insecure but not likely to fall from carrier (4.13 (a) (i))

Nearside Rear Integral body structure or chassis corroded within 30cm of a mounting, but not seriously affecting overall security outrigger (6.2.2 (d) (i))

Offside Front Integral body structure is corroded but structural rigidity is not significantly reduced outrigger near step (6.1.1 (c) (i))

Offside Rear Integral body structure or chassis corroded within 30cm of a mounting, but not seriously affecting overall security outrigger (6.2.2 (d) (i))

Offside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Rear Integral body structure is corroded but structural rigidity is not significantly reduced back panel/inner valances (6.1.1 (c) (i))

Rear Integral body structure or chassis corroded within 30cm of a mounting, but not seriously affecting overall security floor (6.2.2 (d) (i))

Windscreen damaged but not adversely affecting driver's view (3.2 (a) (i))

Anti-lock braking system warning lamp indicates an ABS fault (1.6 (b))

Nearside Rear Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting outriggers x2 (6.2.2 (d) (i))

Offside Front Brake master cylinder/servo mounting prescribed area is excessively corroded inner wing under screenwash bottle (1.1.21 (e) (i))

Offside Front Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting inner wheel arch (6.2.2 (d) (i))

Offside Rear Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting outriggers x2 (6.2.2 (d) (i))

Rear Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting floor strengthener (6.2.2 (d) (i))

Registration plate inscription illegible (0.1 (b))

Battery insecure but not likely to fall from carrier (4.13 (a) (i))

Nearside Rear Integral body structure or chassis corroded within 30cm of a mounting, but not seriously affecting overall security outrigger (6.2.2 (d) (i))

Offside Front Integral body structure is corroded but structural rigidity is not significantly reduced outrigger near step (6.1.1 (c) (i))

Offside Rear Integral body structure or chassis corroded within 30cm of a mounting, but not seriously affecting overall security outrigger (6.2.2 (d) (i))

Offside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Rear Integral body structure is corroded but structural rigidity is not significantly reduced back panel/inner valances (6.1.1 (c) (i))

Rear Integral body structure or chassis corroded within 30cm of a mounting, but not seriously affecting overall security floor (6.2.2 (d) (i))

Windscreen damaged but not adversely affecting driver's view (3.2 (a) (i))

Braking system leaking (3.6.A.1)

Central Rear Brake pipe slightly corroded (3.6.B.2c)

Nearside Rear Brake pipe slightly corroded (3.6.B.2c)

Nearside Rear Shock absorber has a light misting of oil (2.7.3)

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Nearside Rear axle oil seal leaking

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive 3 area's (2.4.A.3)

Rear registration plate deteriorated but not likely to be misread (6.3.1d)

Nearside Front Brake pipe excessively corroded (3.6.B.2c)

Nearside Rear Brake pipe excessively corroded (3.6.B.2c)

Nearside Rear Rear position lamp(s) not working (1.1.A.3b)

Offside Front Brake pipe excessively corroded (3.6.B.2c)

Offside Front Front position lamp(s) not working (1.1.A.3b)

Rear fog lamp not working (1.3.2b)

Nearside Front Brake pipe slightly corroded (3.6.B.2c)

Offside Front Brake pipe slightly corroded (3.6.B.2c)

UNABEL TO SMOKE TEST

Brake load sensing valve seized (3.6.E.3)

Exhaust system not adequately supported (7.1.1)

Nearside Rear Tyre has a tear, caused by separation or partial failure of its structure (4.1.D.1b)

Nearside Registration plate lamp not working (1.1.C.1d)

Nearside Stop lamp not working (1.2.1b)

Nearside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Offside Registration plate lamp not working (1.1.C.1d)

Offside Stop lamp not working (1.2.1b)

Offside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Rear Exhaust has a major leak of exhaust gases (7.1.2)

Rear fog lamp not working (1.3.2b)

Nearside Front Brake pipe slightly corroded (3.6.B.2c)

Offside Front Brake pipe slightly corroded (3.6.B.2c)

UNABEL TO SMOKE TEST

2 rear brake disc score

Centre Brake pipe slightly corroded (3.6.B.2c)

Nearside Front Brake pipe slightly corroded (3.6.B.2c)

Offside Front Brake pipe slightly corroded (3.6.B.2c)

Fuel tank leaking (7.2.3)

Nearside Rear Brake pipe excessively corroded (3.6.B.2c)

2 rear brake disc score

Centre Brake pipe slightly corroded (3.6.B.2c)

Nearside Front Brake pipe slightly corroded (3.6.B.2c)

Offside Front Brake pipe slightly corroded (3.6.B.2c)

Anti-roll bar linkage rubber mounting deteriorated but not resulting in excessive movement (2.4.G.2)

Brake pipe slightly corroded (3.6.B.2c)

Nearside Front Brake pipe slightly corroded (3.6.B.2c)

Offside Front Brake pipe slightly corroded (3.6.B.2c)

brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

rear diff has slight oil leak.

Nearside Inner Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Nearside Rear Brake pipe excessively corroded (3.6.B.2c)

Offside Inner Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Anti-roll bar linkage rubber mounting deteriorated but not resulting in excessive movement (2.4.G.2)

Brake pipe slightly corroded (3.6.B.2c)

Nearside Front Brake pipe slightly corroded (3.6.B.2c)

Offside Front Brake pipe slightly corroded (3.6.B.2c)

brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

rear diff has slight oil leak.

Front Brake pad(s) wearing thin (3.5.1g)

Nearside Front Upper Brake pipe slightly corroded (3.6.B.2c)

front and rear brake discs scored

o/s and n/s rear brake back plates corrosion

Nearside Front Headlamp not working on dipped beam (1.7.5a)

Nearside Front Lower Brake pipe excessively corroded (3.6.B.2c)

Offside Front Brake pipe excessively corroded (3.6.B.2c)

Service brake: efficiency below requirements (3.7.B.7)

Front Brake pad(s) wearing thin (3.5.1g)

Nearside Front Upper Brake pipe slightly corroded (3.6.B.2c)

front and rear brake discs scored

o/s and n/s rear brake back plates corrosion

Nearside Headlamp aim too high (1.8)

Nearside rear parking brake recording little or no effort (3.7.B.6a)

Offside Headlamp aim too high (1.8)

Parking brake: efficiency below requirements (3.7.B.7) DANGEROUS

Exhaust has a major leak of exhaust gases (7.1.2)

Fuel cap/sealing device does not fasten securely maintaining the sealing arrangement (7.2.4b)

Nearside Rear Leaf spring has excessive wear in a shackle pin and/or bush (2.4.B.2)

Offside Rear Leaf spring has excessive wear in a shackle pin and/or bush (2.4.B.2)

Parking brake: efficiency below requirements (3.7.B.7)

Suspension has inadequate clearance with the bump stop (2.4.A.1a)

Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.5b)