2011 Fiat Punto Evo

Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Front Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Nearside Front Lower Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Front Lower Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Front Shock absorbers has light misting of oil (5.3.2 (b))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Oil leak, but not excessive (8.4.1 (a) (i))

Nearside Track rod end ball joint has excessive play (2.1.3 (b) (i))

Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Front Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Nearside Front Lower Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Front Lower Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Front Position lamp not working (4.2.1 (a) (ii))

Offside Front Shock absorbers has light misting of oil (5.3.2 (b))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Oil leak, but not excessive (8.4.1 (a) (i))

Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Nearside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Front Sub-frame is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Rear Sub-frame is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Front Sub-frame corroded to the extent that the rigidity of the assembly is significantly reduced (6.1.1 (c) (i))

Nearside Rear Service brake excessively binding (1.2.1 (f))

Oil leak, but not excessive (8.4.1 (a) (i))

Rear Sub-frame is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Front Service brake fluctuating, but not excessively (1.2.1 (e))

Nearside Oil leak, but not excessive (8.4.1 (a) (i))

Offside Drive shaft joint constant velocity boot severely deteriorated Both inner and outer (6.1.7 (g) (i))

Offside Front Shock absorbers has light misting of oil (5.3.2 (b))

Offside Oil leak, but not excessive (8.4.1 (a) (i))

Nearside Rear Tyre has a bulge, caused by separation or partial failure of its structure (5.2.3 (d) (ii)) DANGEROUS

Front Service brake fluctuating, but not excessively (1.2.1 (e))

Nearside Oil leak, but not excessive (8.4.1 (a) (i))

Offside Drive shaft joint constant velocity boot severely deteriorated Both inner and outer (6.1.7 (g) (i))

Offside Front Shock absorbers has light misting of oil (5.3.2 (b))

Offside Oil leak, but not excessive (8.4.1 (a) (i))

Front Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Exhaust emissions likely to be affected by an exhaust leak (8.2.1.1 (b))

Front Exhaust has a major leak of exhaust gases (6.1.2 (a))

Nearside Front Coil spring fractured or broken (5.3.1 (b) (i))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Front Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Rear heat shield insecure

EXHAUST SHIELD LOOSE

Offside Rear Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Offside Front Coil spring fractured or broken (5.3.1 (b) (i))

EXHAUST SHIELD LOOSE

Offside Rear Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Nearside Rear Tyre worn close to legal limit/worn on edge on legal limit (5.2.3 (e))

exhaust back box in poor condition

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)