2009 Chrysler Grand Voyager

Nearside Front Inner Subframe mounting prescribed area is inadequately repaired fibreglass (5.3.6 (a) (i))

Nearside Front Lower Suspension arm ball joint excessively worn (5.3.4 (a) (i))

Nearside Rear Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Offside Rear Outer Subframe mounting prescribed area is inadequately repaired fibreglass (5.3.6 (a) (i))

Offside Rear Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Rear Exhaust has a major leak of exhaust gases (6.1.2 (a))

Rear Fuel system component leaking fuel filter area (6.1.3 (b) (i))

Front Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Nearside Rear Anti-roll bar linkage pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Rear Anti-roll bar linkage pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Rear Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Oil leak, but not excessive (8.4.1 (a) (i))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Anti-lock braking system warning lamp indicates an ABS fault (1.6 (b))

Nearside Front Position lamp not working (4.2.1 (a) (ii))

Nearside Front Wheel bearing has excessive play (5.1.3 (a) (i))

Offside Front Position lamp not working (4.2.1 (a) (ii))

Offside Rear Shock absorbers has a serious fluid leak (5.3.2 (b))

Offside Rear Wheel bearing has excessive play (5.1.3 (a) (i))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Offside Rear Outer Integral body structure is corroded but structural rigidity is not significantly reduced sill (6.1.1 (c) (i))

Nearside Front Wheel bearing has slight play (5.1.3 (a) (i))

Offside Front Anti-roll bar linkage ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Offside Rear Service brake excessively binding (1.2.1 (f))

Rear Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii)) DANGEROUS

Offside Rear Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Engine covers fitted obscuring some components in the engine bay

Under-trays fitted obscuring some underside components

Nearside Side repeater not working (1.4.A.2c)

Nearside front brake juddering slightly (3.7.A.2b)

Offside front brake juddering slightly (3.7.A.2b)