2006 Seat Leon

Rear Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Exhaust system insecure (6.1.2 (a))

Front Anti-roll bar linkage ball joint dust cover no longer prevents the ingress of dirt both sides (5.3.4 (b) (ii))

Front Outer Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt both sides (6.1.7 (g) (ii))

Nearside Rear Service brake excessively binding (1.2.1 (f))

Rear Exhaust has a major leak of exhaust gases (6.1.2 (a))

Nearside Rear Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii)) DANGEROUS

Nearside Rear Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Rear Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Nearside Front Anti-roll bar linkage ball joint has slight play (5.3.4 (a) (i))

Nearside Rear Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

all brake discs have surface corrosion from lack of use

Front Lower Suspension arm pin or bush excessively worn front bushes both sides (5.3.4 (a) (i))

Rear Brakes imbalanced across an axle (1.2.1 (b) (i))

Nearside Front Lower Suspension arm pin or bush likely to become detached rear bush fitted incorrectly (5.3.4 (a) (ii)) DANGEROUS

Nearside Front Anti-roll bar linkage ball joint has slight play (5.3.4 (a) (i))

Nearside Rear Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

all brake discs have surface corrosion from lack of use

Front Lower Suspension arm pin or bush excessively worn front bushes both sides (5.3.4 (a) (i))

Front Windscreen wiper does not clear the windscreen effectively both sides (3.4 (b) (ii))

Nearside Rear Service brake excessively binding (1.2.1 (f))

Offside Front Outer Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Rear Brakes imbalanced across an axle (1.2.1 (b) (i))

Nearside Rear Tyre has a lump, caused by separation or partial failure of its structure inner sidewall (5.2.3 (d) (ii)) DANGEROUS

Nearside Front Anti-roll bar linkage ball joint has slight play (5.3.4 (a) (i))

Nearside Rear Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

all brake discs have surface corrosion from lack of use

Offside Rear Service brake excessively binding (1.2.1 (f))

Offside Rear Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii)) DANGEROUS

Nearside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Rear Service brake binding but not excessively (1.2.1 (f))

Offside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Rear Service brake binding but not excessively (1.2.1 (f))

Nearside Front Lower Suspension arm has slight play in a pin/bush (2.4.G.2)

Nearside Rear brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Offside Rear brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Nearside Rear Brake pad(s) less than 1.5 mm thick (3.5.1g)

Offside Rear Brake pad(s) less than 1.5 mm thick (3.5.1g)

Nearside Front Lower Suspension arm has slight play in a pin/bush (2.4.G.2)

Nearside Rear brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Offside Rear brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Electronic stability system warning lamp indicates a fault (3.4.1c)

Nearside Front coil spring broken (2.4.C.1a)

Nearside Rear position lamp(s) not working (1.1.A.3b)

Offside Stop lamp not working (1.2.1b)

Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front Brake pad(s) wearing thin (3.5.1g)

Nearside Rear Tyre has a tear, caused by separation or partial failure of its structure (4.1.D.1b)

Offside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front Brake pad(s) wearing thin (3.5.1g)

Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)