2007 Mazda 6

Nearside Rear Stop lamp(s) lens defective which has no effect on emitted light sharp edge covered with tape (4.3.1 (b) (i))

Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

Rear Service brake requirements only just met. It would appear that the braking system requires adjustment or repair (1.2.1 (c))

dent to rear of vehicle

underbody general corrosion /outer sill fitted trim

Nearside Front Headlamp not working on main beam (4.1.1 (a) (ii))

Nearside Rear Stop lamp(s) lens defective which has no effect on emitted light sharp edge covered with tape (4.3.1 (b) (i))

Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

Rear Service brake requirements only just met. It would appear that the braking system requires adjustment or repair (1.2.1 (c))

dent to rear of vehicle

underbody general corrosion /outer sill fitted trim

N/S/F tyre on 4mm tread

O/S/F brakes slightly binding

O/S/F tyre on 4mm tread

Offside Front Headlamp not working on dipped beam (4.1.1 (a) (ii))

Offside Front Upper Anti-roll bar ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Battery insecure but not likely to fall from carrier (4.13 (a) (i))

Nearside Rear Shock absorbers has slight external damage to the casing corrosion (5.3.2 (b))

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Offside Rear Shock absorbers has slight external damage to the casing corrosion (5.3.2 (b))

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Front Brakes imbalanced across an axle Axle 1 (1.2.1 (b) (i))

Nearside Front Position lamp not working (4.2.1 (a) (ii))

Offside Front Service brake excessively binding (1.2.1 (f))

Nearside Rear Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Nearside Rear Shock absorbers has slight external damage to the casing corrosion (5.3.2 (b))

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Offside Rear Shock absorbers has slight external damage to the casing corrosion (5.3.2 (b))

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Offside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Nearside Front Lower Suspension arm ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Offside Rear Parking brake inoperative on one side (1.4.1 (a))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Supplementary restraint system warning lamp indicates a fault (7.1.6 (a))

Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Nearside Rear Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Nearside Rear Valve stem slightly damaged (5.2.3 (j))

Offside Rear Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Offside Rear Valve stem slightly damaged (5.2.3 (j))

Nearside Front Outer Suspension arm ball joint dust cover deteriorated, but preventing the ingress of dirt (2.4.G.2)

Nearside Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Offside Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Offside Rear tyre perished

Play in steering rack inner joint(s) ()

Nearside Track rod end ball joint has slight play (2.2.B.1f)

Offside Track rod end ball joint has slight play (2.2.B.1f)

Nearside Track rod end ball joint has slight play (2.2.B.1f)

Offside Front Tyre has a bulge, caused by separation or partial failure of its structure (4.1.D.1b)

Offside Track rod end ball joint has slight play (2.2.B.1f)

undertrays fitted

Under-trays fitted obscuring some underside components

Front Brake pad(s) wearing thin (3.5.1g)

Offside Front position lamp(s) not working (1.1.A.3b)