2011 Nissan Navara

Front Shock absorbers has a slightly worn bush n/s+o/s lower (5.3.2 (c))

Nearside Front Anti-roll bar linkage ball joint has slight play (5.3.4 (a) (i))

Nearside Front Track rod end ball joint has slight play (2.1.3 (b) (i))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Rear Integral body structure is corroded but structural rigidity is not significantly reduced wheel arch (6.1.1 (c) (i))

Engine MIL inoperative or indicates a malfunction (8.2.2.2 (g))

Front Windscreen damaged and affecting the driver's view of the road (3.2 (a) (ii))

Nearside Front Direction indicator not working (4.4.1 (a) (ii))

Nearside Front Suspension arm ball joint excessively worn (5.3.4 (a) (i))

Nearside Rear Suspension spring mounting prescribed area excessively corroded significantly reducing structural strength front (5.3.6 (a) (i))

Nearside Side repeater not working (4.4.1 (a) (ii))

Supplementary restraint system warning lamp indicates a fault (7.1.6 (a))

Nearside Front Tyre has ply or cords exposed (5.2.3 (d) (ii)) DANGEROUS

Front Shock absorbers has a slightly worn bush n/s+o/s lower (5.3.2 (c))

Nearside Front Anti-roll bar linkage ball joint has slight play (5.3.4 (a) (i))

Nearside Front Track rod end ball joint has slight play (2.1.3 (b) (i))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Rear Integral body structure is corroded but structural rigidity is not significantly reduced wheel arch (6.1.1 (c) (i))

Front Shock absorbers has a slightly worn bush n/s+o/s lower (5.3.2 (c))

Nearside Rear Direction indicator slightly discoloured (4.4.3 (a))

Vehicle structure is corroded but structural rigidity is not significantly reduced n/s+o/s (6.1.1 (c) (i))

Emissions not tested (8.2.2.2 (e))

Engine MIL inoperative or indicates a malfunction (8.2.2.2 (g))

Front Exhaust has a major leak of exhaust gases flexi (6.1.2 (a))

Front Position lamp not working n/s+o/s (4.2.1 (a) (ii))

Nearside Front Windscreen washer provides insufficient washer liquid (3.5 (a))

Nearside Rear Position lamp not working (4.2.1 (a) (ii))

Nearside Rear Stop lamp(s) not working (4.3.1 (a) (ii))

Nearside Side repeater not working (4.4.1 (a) (ii))

Rear Registration plate lamp inoperative in the case of a single lamp or all lamps n/s+o/s (4.7.1 (b) (ii))

Power steering inoperative and steering adversely affected (2.1.5 (c) (ii)) DANGEROUS

Front Shock absorbers has a slightly worn bush n/s+o/s lower (5.3.2 (c))

Nearside Rear Direction indicator slightly discoloured (4.4.3 (a))

Vehicle structure is corroded but structural rigidity is not significantly reduced n/s+o/s (6.1.1 (c) (i))

Exhaust has a minor leak of exhaust gases flexi (6.1.2 (a))

Engine MIL inoperative or indicates a malfunction (8.2.2.2 (g))

Nearside Side repeater not working (4.4.1 (a) (ii))

Offside Front Lower Suspension arm ball joint excessively worn (5.3.4 (a) (i))

Nearside Front Road wheel more than one fixing loose (5.2.1 (a) (ii)) DANGEROUS

Exhaust has a minor leak of exhaust gases flexi (6.1.2 (a))

Front Prop shaft bearing has slight play (6.1.7 (b) (i))

Front Tyre worn close to legal limit/worn on edge n/s+o/s (5.2.3 (e))

Offside Front Lower Suspension arm ball joint has slight play (5.3.4 (a) (i))

Engine MIL inoperative or indicates a malfunction (8.2.2.2 (g))

Offside Front Coil spring fractured or broken (5.3.1 (b) (i))

Front Tyre worn close to legal limit/worn on edge n/s+o/s (5.2.3 (e))

Offside Front Lower Suspension arm ball joint has slight play (5.3.4 (a) (i))

Central Rear Seat belt buckle not functioning as intended (7.1.2 (d))

Engine MIL inoperative or indicates a malfunction (8.2.2.2 (g))

Front Prop shaft joint excessively worn Front propshaft rear u/j (6.1.7 (c) (i))

Nearside Front Lower Suspension arm ball joint excessively worn (5.3.4 (a) (i))

Nearside Headlamp aim not tested (4.1.2 (b))

Nearside Headlamp not working on dipped beam (4.1.1 (a) (ii))

Nearside Stop lamp(s) not working (4.3.1 (a) (ii))

Offside Front Coil spring fractured or broken (5.3.1 (b) (i))

Offside Front Lower Suspension arm ball joint excessively worn (5.3.4 (a) (i))

Offside Headlamp aim too high (4.1.2 (a))

Nearside Front Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Central Exhaust mounting defective (6.1.2 (a))

Central Stop lamp(s) non-obligatory stop lamp not working (4.3.1 (a) (ii))

Nearside Rear Service brake binding but not excessively (1.2.1 (f))

Nearside Rear Tyre obviously under inflated (5.2.3 (l))

Nearside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Nearside Side repeater with a multiple light source up to 1/2 not functioning (4.4.1 (a) (i))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Rear Wheel bearing has slight play (5.1.3 (a) (i))

Steering rack has slight free play detected at steering wheel Steering rack mounting bushes worn (2.3 (a) (i))

Central Rear Seat belt buckle not functioning as intended (7.1.2 (d))

Engine MIL inoperative or indicates a malfunction (8.2.2.2 (g))

Front Prop shaft joint excessively worn Front propshaft (rear u/j ) (6.1.7 (c) (i))

Offside Front Direction indicator not working (4.4.1 (a) (ii))

Offside Headlamp not working on dipped beam (4.1.1 (a) (ii))

Propshaft universal joint worn front prop rear joint

Nearside Rear Rear wheel bearing has excessive play (2.6.2)

Offside Rear Rear wheel bearing has excessive play (2.6.2)

Offside Side repeater excessively damaged so that it is not visible from a reasonable distance (1.4.A.2e)

Trailer electrical socket damaged so that lead cannot be securely connected (1.9.3b)

Windscreen washer provides insufficient washer liquid (8.2.3)

Propshaft universal joint worn front prop rear joint

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)