2008 Fiat Scudo

Nearside Front Upper Anti-roll bar linkage ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Offside Front Coil spring corroded (5.3.1 (b) (i))

Offside Front Upper Anti-roll bar linkage ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Offside Front Suspension arm ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Corrosion under vehicle

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Central Stop lamp(s) not working hi level (4.3.1 (a) (ii))

Offside Rear Direction indicator not working (4.4.1 (a) (ii))

Offside Rear fog lamp not working (4.5.1 (a) (ii))

Offside Stop lamp(s) not working (4.3.1 (a) (ii))

Corrosion under vehicle

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Oil leak, but not excessive (8.4.1 (a) (i))

Offside Front Suspension arm ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Offside Rear Service brake binding but not excessively (1.2.1 (f))

Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

Nearside Headlamp aim too high (1.8)

Offside Headlamp aim too high (1.8)

Front Brake pad(s) wearing thin (3.5.1g)

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

Nearside Front Tyre has a lump, caused by separation or partial failure of its structure (4.1.D.1b)

Offside Inner Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)