2001 Volkswagen Beetle

Exhaust has a minor leak of exhaust gases Centre section (6.1.2 (a))

Oil leak

Wiper blades slightly worn

Nearside Front Tyre(s) of different sizes are fitted on the same axle. (5.2.3 (b))

Exhaust has a minor leak of exhaust gases Centre section (6.1.2 (a))

Oil leak

Wiper blades slightly worn

dipstick tube broken

eml on

front brake pad wear wire broken

slight cracks in front suspension arm bushes

Front Brake pad(s) wearing thin (3.5.1g)

Nearside Front Direction indicator incorrect colour (1.4.A.2f)

Offside Front Direction indicator incorrect colour (1.4.A.2f)

Parking brake lever has little reserve travel (3.1.6b)

Rear Exhaust has a minor leak of exhaust gases (7.1.2)

Parking brake lever has little reserve travel (3.1.6b)

Rear Exhaust has a minor leak of exhaust gases (7.1.2)

Front Tyre(s) incorrect because tyres with different aspect ratios are fitted on the same axle. (4.1.A.1a)

Rear Tyre(s) incorrect because tyres with different aspect ratios are fitted on the same axle. (4.1.A.1a)

Front number plate cracked

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Rear registration plate delaminated but not likely to be misread (6.3.1d)

Nearside Front Anti-roll bar has slight play in a pin/bush (2.4.G.2)

Nearside Front Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Front Anti-roll bar has slight play in a pin/bush (2.4.G.2)

Rear Brake pad(s) wearing thin (3.5.1g)

Offside Front constant velocity joint gaiter split (2.5.C.1a)

Nearside Front Direction indicator slightly discoloured (1.4.A.2f)

Offside Front Direction indicator slightly discoloured (1.4.A.2f)

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

exhaust bracket broken

exhaust rattling around catalyst

exhaust bracket broken

front & rear tyres different sizes

rattle inside catalyst

wipers smearing

Exhaust has a rattle coming from inside

O/side front tyre wearing on inner edge

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)