2003 Mazda 323

Engine covers fitted obscuring some components in the engine bay

Front Exhaust has a minor leak of exhaust gases (7.1.2)

Under-trays fitted obscuring some underside components

coil spring corroded (2.4.C.1b)

rear arches getting rusty

Nearside Outer Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Nearside front brake binding (3.7.B.1)

Offside Front Brake hose has insufficient room to move, resulting in fouling on any part (3.6.B.4a)

Offside Outer Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Engine covers fitted obscuring some components in the engine bay

Front Exhaust has a minor leak of exhaust gases (7.1.2)

Under-trays fitted obscuring some underside components

coil spring corroded (2.4.C.1b)

Nearside Headlamp not working on dipped beam (1.7.5a)

Offside Front position lamp(s) not working (1.1.A.3b)

Offside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Rear Brake pad(s) less than 1.5 mm thick (3.5.1g)

Registration plate lamp not working (1.1.C.1d)

Nearside Rear Anti-roll bar linkage has excessive play in a ball joint (2.4.G.2)

Nearside Rear Tyre has a bulge, caused by separation or partial failure of its structure (4.1.D.1b)

Rear Brake pad(s) less than 1.5 mm thick (3.5.1g)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Rear Anti-roll bar linkage has slight play in a pin/bush (2.4.G.2)

Rear Anti-roll bar rubber mounting deteriorated but not resulting in excessive movement (2.4.G.2)

Front Brake pad(s) wearing thin (3.5.1g)

Front Tyre worn close to the legal limit (4.1.E.1)

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

Front registration plate character(s) likely to be misread (6.3.4b)

Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)