2005 Mazda 6

Emissions not tested due to exhaust blowing badly (8.2.1.2 (d))

Exhaust has a major leak of exhaust gases (6.1.2 (a))

Nearside Front Service brake excessively binding (1.2.1 (f))

Nearside Rear Road wheel badly distorted (5.2.2 (c) (i))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength end of sill (5.3.6 (a) (i))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength of outer sill (5.3.6 (a) (i))

Offside Front Lower Suspension arm ball joint excessively worn front arm ball joint (5.3.4 (a) (i))

Offside Front Lower Suspension arm pin or bush excessively worn front arm bush (5.3.4 (a) (i))

Offside Front Wheel bearing rough when rotated (5.1.3 (b) (i))

Offside Rear Inner Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill (5.3.6 (a) (i))

Offside Rear Lower Suspension arm corroded and seriously weakened (5.3.3 (b) (i))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength end of sill (5.3.6 (a) (i))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength of outer sill (5.3.6 (a) (i))

Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside Front Road wheel slightly distorted (5.2.2 (c) (i))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Front wheel bearing not checked due to brake binding

Nearside Rear Lower Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Stop lamp(s) non-obligatory stop lamp not working (4.3.1 (a) (ii))

plastic sill covers fitted at time of test

this vehicle has been undersealed

Brake fluid significantly below minimum mark (1.1.10 (d) (ii))

Nearside Front Headlamp not working on dipped beam (4.1.1 (a) (ii))

Offside Outer Front constant velocity joint gaiter damaged, but preventing the ingress of dirt (2.5.C.1a)

nail in nearside rear tyre tread.

Central Exhaust has a major leak of exhaust gases (7.1.2)

Exhaust emissions Lambda reading after 2nd fast idle outside specified limits (7.3.D.3)

Windscreen washer provides insufficient washer liquid (8.2.3)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1) DANGEROUS

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1) DANGEROUS

Offside Outer Front constant velocity joint gaiter damaged, but preventing the ingress of dirt (2.5.C.1a)

nail in nearside rear tyre tread.

Nearside Rear Registration plate lamp not working (1.1.C.1d)

Nail in offside front tyre

Offside Front Lower Suspension arm ball joint dust cover deteriorated, but preventing the ingress of dirt (2.4.G.2)

Nail in nearside rear tyre

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

noise from exhaust (rattle)

Front Power steering ram(s) has slight seepage from a component (2.3.3b)

Rear Brake pad(s) wearing thin (3.5.1g)

Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Rear Brake pad(s) wearing thin (3.5.1g)