2008 Ford Ka

Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))

Front Windscreen wiper does not clear the windscreen effectively both (3.4 (b) (ii))

Nearside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Nearside Rear Inner Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill (5.3.6 (a) (i))

Nearside Rear Inner Suspension component mounting prescribed area excessively corroded significantly reducing structural strength wheel arch / sill (5.3.6 (a) (i))

Nearside Rear Sub-frame pin or bush excessively worn forward most (5.3.4 (a) (i))

Offside Outer Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill (5.3.6 (a) (i))

Offside Rear Inner Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill (5.3.6 (a) (i))

Offside Rear Inner Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill / wheel arch (5.3.6 (a) (i))

Offside Rear Outer Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill (5.3.6 (a) (i))

Offside Rear Sub-frame pin or bush excessively worn forward most (5.3.4 (a) (i))

Offside Rear Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced behind wheel arch above exhaust (6.1.1 (c) (i))

Offside Front Seat belt slightly damaged (7.1.2 (b) (i))

general vehicle condition very rusty with multiple poor repairs in the past

Exhaust silencer insecure rearmost back box mount (8.1.1 (b) (i))

Nearside Front Inner Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting inner sill behind jacking point (6.2.2 (d) (i))

Offside Outer Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting marked in yellow 3 holes along the sill (6.2.2 (d) (i))

Rear Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting both sides axle inner sill by rear axle mounts (6.2.2 (d) (i))

Offside Front Coil spring fractured or broken (5.3.1 (b) (i))

Front Both front tyres worn edges

Nearside Front Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Nearside Front Headlamp not working on dipped beam (1.7.5a)

Front Both front tyres worn edges

Nearside Front Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

nail n/s/f tyre

O/S/Rear tyre is cracked around edge of tread.